The Pioneer DJC-STS1 DJ Booth Standprovides an adjustable height and angle for ergonomic comfort when holding the DDJ-XP1 add-on controller, RMX-1000 remix station, or a laptop.

Holds DDJ-XP1 and RMX-1000    Holds Laptops    Ergonomic Height and Angle    Sturdy Design

• Sturdy, ergonomic DJ stand provides comfort and ease of use
• Ideal for DDJ-XP1 add-on controller and RMX-1000 remix station
• Well suited for laptops
• Adjustable height and angle

Related Questions and Answers

Q: 1. No dimensions are listet in the specs. What are the interior and exterior dimensions for the DDJ 800 case? Inches suffice.

A: Pioneer DJ does not list the dimensions of the case anywhere on the web, but if you look at the photo, you can see that the controller pictured inside the case is the DDJ-800. Since the case is specifically for this controller, it fits snug inside the interior of the case with no extra room to slide around. Dimensions of the DDJ-800 are 24.9 x 13.2 x 3.0" (632.0 x 334.0 x 76.2mm) and the bag is just slightly larger. Judging by the way the controller fits as shown, I would estimate the dimensions of the bag to be approximately 25 x 14 x 3.5".

Q: 2. Will these fit the discontinued Pioneer HDJ-1000?

A: These Pioneer DJ Leather Earpads are not compatible with the HDJ-1000.

Q: 3. Is the screen made of plastic or glass?

A: The Pioneer DJ XDJ-RX3 has a glass 10.1-inch touchscreen.

Q: 4. Does it have leveling feet?

A: Yes it does,

Q: 5. Can you recommend a cartridge for this turntable?

A: For home use: The Shure M97XE is a highly sensitive turntable cartridge designed to produce audio with extreme accuracy and detail. The MX97E provides long term listening without ear fatigue by reproducing high frequencies and low passages with extreme accuracy and without distortion and noise. Shure M97XE High Accuracy, Low Mass Turntable Cartridge B&H # SHM97XE

Q: 6. Would this power something passive like a Yamaha BR15M?

A: No, the Pioneer DJ XDJ-RR All-In-One DJ System does not have a built-in power amplifier so it does not have the ability to power a passive speaker like the Yamaha BR15M 15" 2-Way 400 W Floor Monitor. You would either need to use a power amplifier or an active (powered) speaker.

Q: 7. Just bought this turntable. My question is: What is the sub weight for? I haven't attached it to the counterweight yet. Please explain in detail as the manual didn't do a great job. Thanks.

A: After installing the cartridge and headshell on the tonearm it will need to be balanced with the counterweight. With the tonearm off the rest about an inch or 2 over the platter you will need to adjust the counterweight until the arm is floating parallel with the platter. For most cartridges this should only take a few turns forward on the weight. For heavier cartridges, you will find that the counterweight is unable to balance your tonearm. You can offset the weight of a heavy cartridge by installing the sub-weight on the rear of the tonearm, and follow the balancing procedure again.

Q: 8. Is Virtual DJ 8 compatible?

A: Thank you for your question. This controller can be used with virtual dj 8.

Q: 9. The DJM 250 mk2 has one XLR master output and one RCA (also master) output. Does this mean that the unit can be connected to a master only (choosing either RCA or XLR), or does it mean that the XLR can be used for the master speakers and the RCA for the booth speakers? Or (again), is "booth" not an option.

A: Both the XLR and RCA outputs will work at the same time. Ususlly the XLR will feed the house PA system and the RCA would feed the monitors in the booth.

Q: 10. Will this wire work on Bose QuiteComfort 35 ii Headphones?

A: Yes, using the included 1/4" to 3.5mm screw-type adapter with the Pioneer DJ Coiled Cable for HRM-7, HRM-6 & HRM-5 Headphones (3.9'), the Bose QuietComfort 35 Series II Wireless Noise-Canceling Headphones (Black) will work.