The Tannoy VTH Top Hat is a pole mount top hat accessory that replaces the blank panel that is included on the VX series loudspeakers, allowing the speaker to be mounted on standard 35mm speaker poles. Simply remove the four screws holding the blank panel and replace with the VTH Top Hat using the same screws. The top hat features a hard-wearing, semi-matte, black powder coat finish that ensures long-term use.

Suitable for Standard 35mm Speaker Poles    Easy Installation    Replaces Blank Panel on VX Loudspeakers    Semi-Matte, Black Powder Coat Finish    Limited 10-Year Warranty

• Pole mount top hat accessory for VX loudspeakers
• Suitable for 35mm poles
• Hard-wearing semi-matte, black powder coat finish
• Fixed in position with 4 securing screws
• Limited 10-year warranty

Related Questions and Answers

Q: 1. Does this work with Hikvision DS-2CD7A26G0/P-IZHS8 (LPR camera) that B&H sells?

A: The Hikvision PM Universal Pole Mount Adapter BH #HIPM is not the recommended mount for the Hikvision DeepinView DS-2CD7A26G0/P-IZHS8 2MP Outdoor Network LPR Bullet Camera with Night Vision & 8-32mm Lens BH #HI26G0PIZHS8. The Hikvision PM1 Pole Mount Adapter for DS-2CD26x5/27x5FWD Cameras B&H # HIPM1 MFR # PM1 is the recommended pole mount adapter for the Hikvision DeepinView DS-2CD7A26G0/P-IZHS8 camera.

Q: 2. Hi all. I can't tell from the photos but does this come with a 3/8" stud on a platform so I can mount a ball head on it? Or will I need to buy a half ball leveling adapter to get the stud? Thank you.

A: A 3/8"-16 Low-Profile Tie-Down Adapter is defined as being included, but to properly mount any devices and achieve proper leveling, we recommend a half ball leveling adapter.

Q: 3. What is the weight limit for this mount?

A: The Hikvision PM Universal Pole Mount Adapter (BH # HIPM) has a maximum payload of 6.5 kg. NOTE: The pole’s load capacity should be more than three times the weight of the camera and the bracket.

Q: 4. Will this fit Manfrotto 502HD?

A: Yes it will. B&H# MAMVH502A, which is the 75mm version of the 502HD, will work very well in this 75mm Hi-Hat.

Q: 5. Does it run off 48 volt phantom power when the included XLR adapter cable is use?

A: No, the Wooden Camera VX Skateboard Camera Mic is powered by an internal LiPo battery. The mic does not operate using phantom power. A 3.5mm coiled cable is included with the mic, but the XLR adapter cable is available separately, which is the Wooden Camera VX Skateboard Camera Mic XLR Adapter Y-Cable - 16" (B&H # WO268800).

Q: 6. Do you need to change the fuse to use it with 220v ?

A: Yes, the PreSonus AIR10 2-Way Active Sound-Reinforcement Loudspeakers (Single) will need a different fuse to operate at 220V. The fuse included fuse for operation at 100 to 120V is a T5AL 250V, while the fuse required for operation at 220 to 240V is a T2.5AL 250V.

Q: 7. cuanto mide extendida y cuanto cerrada en centimetros?. gracias

A: Buenos dias, cerrado mide 70 centimetros y extendido 300 cm ( (0.7 to 3.0m) si requiere mas informacion puede comunicarse con nosotros por e-mail a a href= http://spanish@bhphotovideo.com target= _blank spanish@bhphotovideo.com/a

Q: 8. Does this product fit non-round items like a hockey stick?

A: Hey, Amanda. I dont have the mount or my hockey stick near me. So, Im not sure the width of the mount would fit around a stick. If it would fit the clamp is tight enough to hold a stick and wouldnt slip in my opinion. Unless your slap shot is as hard as mine. :) Good idea for the mount in my opinion. Hope this helps.

Q: 9. What is the actual weight of this mount. In the "SPECS" tab, it says 15 lb (6.8 kg) but under it in shipping, it says 9.095lb?

A: Hi, the correct weight for this product is 15 lbs (6.8 kg)

Q: 10. I have the Magnus REX VT-6000 2-Stage Video Tripod with Fluid Head. What 75mm adapter would work with that fluid head?

A: The Benro 75mm Hi-Hat will not need an adapter to use the head on the Magnus REX VT-6000 2-Stage Video Tripod's fluid head.