The Photoflex Telescopic Litedisc Holder is adjustable, easy to swivel and rotate for precise position. The Holder extends from 36 to 67".

The Litedisc Holder comes complete. It includes an extension arm, lightstand attachment and two movable spring clips.

The Litedisc Holder fits and locks to the top of any lightstand that has a Baby (5/8") top stud.

Swivel Mount    Reflector Disc Clips

Holds the smallest 12" Litedisc, up to the largest 52" and 41" x 74" oval Litediscs (A sandbag for your stand is suggested for larger discs)

May be used as a boom for a small light fixture

Related Questions and Answers

Q: 1. can this be used to hold a circular reflector horizontally, to create an overhead white surface for bounce flash? (like a white ceiling)

A: Yes it can hold a reflector horizontally. If you look at the magnified image of it you'll see that the two clips that hold the reflector are adjusted with a thumb turn screw. This allows the clips to not only slide along the arm but also rotate 360 degrees around the arm as well. So they can be turned horizontally. Or in any orientation to the arm.Just be aware you may need to add a bit of weight to help counter balance the arm for safety. As well as a sand bag for the light stand. Hope this helps.

Q: 2. Is everything pictured in the photo included? Or, just some of the parts? I do not understand the item description.

A: This is a replacement for the swivel/tilt mechanism. It is not a full reflector boom.

Q: 3. Would one of these holders hold the larger 42 x 72 rectangular discs or would we need two to hold in in place?

A: definitely 2 ! And you still need sandbags! But it works awesome as long as it's not too windy. The wind can be challenging.

Q: 4. Is the 16.2mm the maximum size of the hole and can I use it with a 12.7mm shaft?

A: The Photoflex Small Clip Collar with Knob for LiteDisc Holder has a maximum opening of 16.2mm. It would not be suitable with a 12.7mm (about 0.5 in) shaft.

Q: 5. What do you mount the holder on, a light stand?

A: It has a bracket that attaches to the top of a light stand. You can tighten and adjust it as needed.

Q: 6. Could these reflector hang from an extra tripod with a clip of sorts?

A: Yes.

Q: 7. how many f stops does it use in sunlight ?

A: Approximately 2 stops

Q: 8. What accessory do I need so I can use the tip of it for mounting light or microphone ? I own one and it's not threaded, so I can't put anything right now. Thank you.

A: You Can use an Impact Rapid Baby to 3/8 or 1/4 threaded male adapter

Q: 9. How many stops diffusion does this give? 3/4 (like on a ScrimJim)? Or more like 1.25 - 1.5 like the diffusion fabric on Photflex soft boxes?

A: With this diffuser, you would lose about 1.25 stops of light.

Q: 10. Is the part that attaches to the stand made of metal?

A: Yes the stand mount on this arm is made of aluminum.