The beige Mogan 1.2mm Shure Wireless Transmitter Cable Beige 6'is a 6' long analog audio cable designed to replace the broken, worn, or missing microphone cable for your Mogan mic. Its TA4F connector ensures proper connectivity between your Mogan microphone and Shure transmitter.

For Shure Transmitters    1.2mm Cable Diameter    6' Length

1.2mm cable diameter

TA4F connector for compatibility with Shure transmitters

Related Questions and Answers

Q: 1. Is it compatible with any mic system

A: No. This transmitter can only be used with these Shure receivers- BLX4, BLX4R, and the BLX88. Either receiver must be in the same frequency range as that transmitter, specifically range J10. Please also note, that transmitter has a ta4m connection, and can only be used with mics wired for Shure systems utilizing a ta4f on the mic.

Q: 2. We have the Shure MX153 earset. It needs to be replaced. Will this this work ?

A: Yes, the Pyle Pro PMHMS20 Omnidirectional Headset Microphone for Shure Wireless Transmitters (Beige, TA4F) would be capable of replacing the Shure MX153 Earset Headworn Microphone to work with Shure transmitters with onboard TA4 connections. Both mics are omni pickup pattern, but the Pyle is a dual ear headset mount as opposed to the MX153's single ear configuration.

Q: 3. Does ulxd1 transmitter h50 work with ulxd4 h51 receiver?

A: Yes, the Shure ULXD1 Digital Wireless Bodypack Transmitter for the H50 frequency band (534 to 598 MHz) will work with the Shure QLXD4 Digital Wireless Receiver for the H51 frequency band (534 to 598 MHz) since the H50 and H51 frequency bands overlap and the Shure ULX-D and QLX-D components are compatible for use together.

Q: 4. Will this transmitter work with the ULXP4 receiver?

A: No it is not. The Shure ULXD1 is a digital wireless bodypack transmitter compatible with ULX-D and QLX-D receivers only.

Q: 5. Even though the Medium waist strap is 39" in length, can it be used on someone with a waist between 30"-32"?

A: No. it woulld be best to use the Viviana Small Wireless Transmitter Waist Strap (Beige) BH #VIVSWSBG.

Q: 6. What is Lemo3 and do I need it for a gutair to connect to the Ulxd... thx

A: The Shure ULXD1 Digital Wireless Bodypack Transmitter with LEMO3 has a LEMO 3-pin input connector. The same transmitter is also available with a TA4 connector. These are two different types of audio connections which you would use to connect audio sources to the transmitter.

Q: 7. Funciona si uso un receptor Shure BLX4 H9 con un transmisor Bodypack H10?

A: No. El transmisor y el receptor deben estar en el mismo bloque de frecuencia.

Q: 8. Will this cable work with BH Part # MOEXOBGSE?

A: Yes, the Mogan 2mm Replacement Microphone Cable for Sennheiser Wireless Transmitters is a compatible replacement for the original cable included with the Mogan Elite Omni Earset Microphone for Sennheiser Wireless Transmitters.

Q: 9. i get a lot of popping using the wl185 with the ulxd1. what else can i try?

A: It's depends on what you mean by popping. If its electronic noise or acoustic plosives. If it sounds electronic then get a new mic. If it's vocal plosives then move the mic so it's not so close to the persons mouth.

Q: 10. Does the transmitter overheat from frequent use?

A: Temperature with use over time is not a commonly defined specification for wireless transmitters such as the Shure ULXD1 Digital Wireless Bodypack Transmitter with TA4M. However, increased temperatures with long periods of use is common for products in this category.