The Canon RS-RC07 Remote Controllerfrom Canon RS-RC07 Remote Controlleris designed to be used with the REALiS WUX7000Z Pro AV projector. It has a communication range of approximately 26' within ±25° horizontally and vertically of an infrared remote receiver. This 3VDC remote controller is powered using two AA batteries (included).

For REALiS WUX7000Z Pro AV Projector    Two AA Batteries Included    Approximately 26' Communication Range

Power button, D. Zoom button, Fn button, pointer buttons, OK button, Focus button, Zoom button, input A-C button, Aspect button, Test Pattern button, Channel button, Image button, Freeze button, Exit button, input button, Volume button, Number buttons, Mute button, Menu button, Lens-shift button, Keystone button, Auto PC button, Split button, Blank button

Related Questions and Answers

Q: 1. Is this product compatible with 77D?

A: Go away!

Q: 2. Does the Canon remote switch RS-80N3 work with the Canon 80D?

A: No, the 80D has a different pin connector than the 80N3. You would ned to use the RS-60E3 (if Canon) or similar aftermarket remote.

Q: 3. is this compatible with EOS 6D Mark II ?

A: Yes. I have one for my 6D Mark II.

Q: 4. Does the Canon RS-60E3 work with Canon EOS R cameras?

A: Yes, the EOS R uses the RS60E3 for its shutter release.

Q: 5. Can this remote switch be used in AV and TV mode by holding down the button for say 20 seconds and then releasing it to take the picture?

A: This remote is essentially an extension of the regular shutter button on the camera. If you depress it half-way down, it will deploy the autofocus on the camera. If you depress the button fully it will take the photo. If you want to delay the cameras shutter from firing for 20 seconds prior this device would not accommodate that. You would need to purchase a remote with an intervalometer capability. Below is a recommendation for the Vello Shutterboss remote which will allow you to set a timer delay and or intervals for the camera to be triggered at. See the link below for details:http://bhpho.to/1bjB88q

Q: 6. Is this compatible with the 5D Mark III?

A: Yes, the Canon Remote Switch RS-80N3 is fully compatible with the N3 3-pin connector built into the Canon EOS D Mark III DSLR camera.

Q: 7. I'm looking for a remote for my T5 rebel? I bought the pro master , I can not get it to work.

A: I'm not familiar with the plug set up for the T5. The RS80N3 will not work on my Canon 60D, but it works fine on my 6D full frame camera. The plug is much

Q: 8. I have this on my 40D...will it work on the 70D?

A: No, it is not compatible with the 70D.

Q: 9. Does this remote have an internal battery and if so what number is it? Is it powered by the camera?

A: It does not have an internal battery, it is powered by the camera.

Q: 10. Can I use this remote when my camera is set up for back button focusing? Will I need to manually focus first and then use the shutter button?

A: Yes, you will have to use the BBF button to focus your camera the same as you would if your were holding it. Think of the RS-80N3 as a second shutter button on a long cord.