The Matthews Pipe Spreader | Durable Pipe Spreading Toolfrom Matthews Pipe Spreader | Durable Pipe Spreading Toolis a 2-piece system that allows positioning a pipe between two flat surfaces like ceilings or walls. Both pieces have a receiver that accepts 1-1/4" pipe and a flat welded plate base. One of the pieces has a telescoping action to tighten the pipe's fit between the surfaces.

Suspends a Pipe between 2 Flat Surfaces    2-Piece System

Related Questions and Answers

Q: 1. How many end caps does it come with?

A: Each pipe had a pair of plastic end caps, so the kit has twelve in total.

Q: 2. Hi there. What's the maximum payload this can handle?

A: The payload that you can support with the Matthews Pipe Spreader BH #MA429025 varies. The type of pipe, the type of walls and if the supports are nailed or bolted to the walls will all affect the load rating possible.

Q: 3. How many total pieces come in this kit?

A: The Matthews Pipe Spreader is made up of two pieces.

Q: 4. How many lengths can be used with out a middle support?

A: The pipes are very strong, so its possible to use the full length (two 3-pipe tracks) without a middle support, but that depends more on the weight of your camera package than anything.

Q: 5. Are the threads etched on to the outside of the pipe or does this come with threaded connectors?

A: the pipes have a thread cut inside, then they machined nipples with 2 male threads on them to join the tubes. you keep the nipple mounted on one side, and there is a protective rubber cap for when not in use.they are awesome for when you need to be moving around location, rather than dragging long pipe around.the threads are a little fine, be careful getting them started so you don't strip them.

Q: 6. Could this work for 1" square pipe?

A: It was designed for 1 to 1 1/4" round pipe it is not for square pipes.

Q: 7. Whats the weight limit?

A: According to the manufacturer, the DigitalFoto Solution Limited Swiveling Pipe C-Clamp has a maximum load capacity of 110.23 lb (50 kg).

Q: 8. Does the clamp include the spider clamp quick release mount as pictured in one of the images?

A: I'm not sure what image you're referring to, but it only comes as the clamp.

Q: 9. What's the size of the pipe this mount would require? Will it fit a pipe that is 1.5 inches in diameter?

A: The PTZCam Universal PTZ Bracket (Single Pipe Mount) is a 1" pipe mount.

Q: 10. can the universal track ends hold these pipes?

A: Yes, because the Dana Dolly Portable Aluminum Pipe Kit is made and compatible with the Dana Dolly Universal Track Ends.