Use this CAMVATE 1/4"-20 Hex Button Cap Adapter Set (4-Pack)of four screws from CAMVATE 1/4"-20 Hex Button Cap Adapter Set (4-Pack)with your rigs and cages to connect various accessories and components. The silver .73" long screw has a hex button cap design and is made of stainless steel. An Allen wrench is included.

4-Pack of 1/4"-20 Screws    Hex Button Cap Design    Use with Rigs and Cages    Stainless Steel Construction    Allen Wrench Included

Related Questions and Answers

Q: 1. What is the max load at full extension?

A: The load capacity is not rated. In almost every case it will be the stand that determines the load limits of the grip arm.

Q: 2. Is the grip handle (knuckle) fixed in position at the end of the rod (arm) or can it slide along the arm and be tightened in any position?

A: Fixed position, you get a 2nd grip head to slide the arm up & down

Q: 3. What size is the threaded hole on the bottom of the unit?

A: The ColorKey AirPar HEX 4 Battery-Powered Wireless Uplight (BH # COAPH4) is designed to sit reliably on the floor with its built-in kick stand. The threaded hole you are referring to is for the fuse.

Q: 4. What's the length of the screw, not including the base?

A: The total length of each screw in the CAMVATE 1/4"-20 Long Slotted Knurled Mounting Screw (2-Pack) is a total length or 0.8" per screw. or about 20mm.

Q: 5. will this fit the new leica d-lux 8?

A: Yes, the Vello 2X Soft Shutter Button Set will work on the Leica D-Lux 8 Digital Camera.

Q: 6. What size hex wrench would be needed for tightening these studs? Note that I realize I can use an adjustable wrench, but being made of brass, I prefer to use a standard combination wrench to perform tightening.

A: Hi,5/8 or 16mm. Regards,Will H

Q: 7. Where is it made?

A: This product has a Country of Origin of China.

Q: 8. how much weight does it support? can it be used as a boom?

A: While extension grip arms do not often list load capacity, the approximate load capacity for a 40 inch extension grip arm would be approximately 10 lbs. It can be used as a boom for lightweight items or light fixtures.

Q: 9. Does the 1/4"-20 insert come out so that the ball head can go on a 5/8" light stand?

A: No, it does not. Some 5/8" studs have a 1/4"-20 thread on them, which these can mount to. If your light stands are unthreaded, you could use a ball head like this https://bhpho.to/2KH0vjC, or get an adapter like this: https://bhpho.to/37nNymD

Q: 10. Can I know what is the base diameter of this?

A: The diameter for the base of this product is 23mm.