The Acebil CS-18/T75CG Professional Tripod Kitfrom Acebil CS-18/T75CG Professional Tripod Kitis a kit that includes a 75mm CH1 fluid head, a T75CG carbon fiber tripod, a ground spreader, and a S-52 carry case. The tripod features a two-stage design and carbon fiber construction that supports loads up to 15.4 lb. It provides a height range from 24.4 to 70.9" and comes equipped with a sliding quick release plate and pan bar.

75mm CH1 Fluid Head    T75CG Carbon Fiber Tripod    Ground Spreader    S-52 Carry Case

Related Questions and Answers

Q: 1. How do I get the copylight onto the holder that slides onto the horizontal bars? It appears the round piece should slide all the way into the round section on the edge of the copylight and then the knob secures it, but I can't get it to go past the edge of the inside hole (if that makes any sense). Thanks for your help.

A: If you are still having an assembly problem, try to completely remove the tightening nob on horizontal bar, that may give you the clearance you need. If all else fails, try getting Tech Support at Beseler You may replacement parts. Their Number is 800-237-3537

Q: 2. Minimum Elevation9.5 (241.3 mm) Is that from the screw? Is that .../ I want to use it with a macro lens. Not sure of these numbers

A: Yes, I believe it is the distance from the table to the camera mounting screw. I checked mine - it's closer to 8.75 table to screw (mine was purchased June-2014).

Q: 3. Can this dolly be used on a tripod without spiked feet?

A: The Acebil D3 is only compatible with spiked feet tripods.

Q: 4. will this work on my canon XA20 video camera?

A: This should work well with the XA20 plus the zoom control is of the LANC type so it interface correctly with the camcorder and you will have smooth zooms.

Q: 5. What is the screw size for mounting the camera or head to the Acebil MP-285C?

A: This monopod has a reversible stud that provides a 1/4-20 or 3/8"thread.

Q: 6. Can I use this with the iFootage Wild Bull T5S with the spiked feet (rubber feet removed)?

A: Yes, the Acebil D3 Dolly for Professional Tripods is compatible with the iFootage Wild Bull T Series T5S Aluminum Alloy Tripod.

Q: 7. will this work on canon xa20?

A: This tripod will support and the remote will control the Canon XA20 like they were made for each other.

Q: 8. What is the height of this tripod?

A: The tripod has a max height of 59 inches tall.

Q: 9. Is the head removable?

A: Yes

Q: 10. what is the minimum working height?

A: They do not list the minimum working height, but the center column can turn 90 degrees and the legs can open to a very wide angle so you can get very close to the ground. I would say around 4-5 inches from the ground.