This CAMVATE 1/4"-20 Mini Ball Head & Shoe Mount Adapter 2-Packis a 1/4"-20 screw mini ball head with a shoe mount adapter screwed on the end, allowing you to attach external accessories. The shoe mount adapter could be attached directly to a camera or other shoe accessories like a top handle, a microphone, or a flashlight.

Mounts Accessories to Camera    Compact and Lightweight    1/4"-20 Thread

Related Questions and Answers

Q: 1. What is the load capacity?

A: The load capacity of the Smallrig Camera Hot Shoe is 3kg or 6.6lb.

Q: 2. What is the spacing between holes on the flange? (length of the side of the square made by the four holes center to center)

A: The measured distance between each mounting hole is 17.68mm.

Q: 3. Can the cold show mount be removed and used as 1/4"?

A: There is actually a 1/4"-20 thread under the cold shoe already. If you would like to mount this to something that also has a 1/4"-20 thread a basic spigot adapter would be the safe choice. https://bhpho.to/2TIsCA9

Q: 4. Is it made of aluminum or steel?

A: The SmallRig Double Ball Head with Cold Shoe & 1/4"-20 Stud is made of an aluminum alloy plus stainless steel.

Q: 5. How close to 1-11/16" would this be in diameter when closed? Also, my tube is 5-3/8" in circumference, if that helps. FYI: It's the SUTEFOTO TP25-RGB.

A: This is a T12 clip. T12 is a 1.5" diameter.

Q: 6. Do these work with the HTC Vive Base Stations?

A: Yes it will thread into the 1/4-20 female threaded bushing of the HTC VR Base Station for Vive.

Q: 7. Can this clamp be used simply to mount on a tripod with the 1/4" screw hole? I don't need the light stand adapter

A: While that is not the intended use for the CAMVATE Smartphone Clamp with Ball Head Mount and Light Stand Adapter, you should be able to mount it directly to a tri-pod without the light stand adapter.

Q: 8. Read reviews for similar mount brackets from various sources most have same problems with poor quality. Is mount pot metal?

A: The CAMVATE 1/4"-20 Mini Ball Head Wall/Ceiling Mount is made of an aluminum alloy.

Q: 9. Does the 1/4"-20 insert come out so that the ball head can go on a 5/8" light stand?

A: No, it does not. Some 5/8" studs have a 1/4"-20 thread on them, which these can mount to. If your light stands are unthreaded, you could use a ball head like this https://bhpho.to/2KH0vjC, or get an adapter like this: https://bhpho.to/37nNymD

Q: 10. What are the Allen wrenches for?

A: On the side of each mount you will see the threading that the Allen Wrenches are used for to adjust the tension. https://bit.ly/36iS4mj