Patterns, or gobos, are widely used by designers in theatre, film, photography and television to create atmosphere, project scenery, and generally enhance the visual impact of their lighting.

Conceived by some of the world's leading lighting designers, the Rosco range presently includes hundreds of standard steel gobo designs.

To insure design integrity the patterns are etched using a precise double-sided process on stainless steel. The result is durable, high quality patterns which will withstand the extreme heat at the gate of ellipsoidal spotlights.

Rosco steel gobos are round to allow for rotation in the gate when aligning the projected image.

The standard "B" size is suitable for most fixtures with a 6" lens when used with a Rosco Pattern Holder or the holders of other manufacturers.

Trimming of patterns, where necessary, can be easily accomplished with a pair of scissors.

Related Questions and Answers

Q: 1. The top surface has a "mono/sum" printed on it. Is there a right-side switch which sums both inputs to one of the outputs?

A: The Mono/Sum switch on the right side of the Radial Engineering Trim-Two Stereo DI with Volume Control converts both outputs to dual mono, so using either output will deliver the same exact mono signal, so you have the option of using both outputs or just one output for your setup.

Q: 2. When using two condenser mics will it pass through phantom power to each individual microphone?

A: No. The Radial Engineering MIX 2:1 2-Channel Audio Combiner & Mixer blocks phantom power.

Q: 3. Will this pass phantom power?

A: Yes, the Radial Engineering JS-2 Two-Way Microphone Signal Splitter can pass phantom power through the main output.

Q: 4. Regarding the below, could you please explain to me, a novice, what it means to be "wired in parallel with the XLR input." 1/4" TRS Input. Connects from your recording workstation and is suitable for both lo-Z and hi-Z sources. Wired in parallel with the XLR input.

A: The parallel wiring means the 1/4" TRS input and the XLR input are wired so they are independent of each other and each have their own signal path.

Q: 5. So the 1/4" thru port acts as both an output bypass and and a single channel input that sums a signal sent out the XLR output?

A: The Radial Engineering ProAV1 Passive Multimedia Direct Box (B&H # RAPROAV1) features front-panel connectors that can also be used as throughputs to allow multiple patch points. A summed mono output is available via the balanced XLR output.

Q: 6. Can I hook up a compressor to the Insert send/recv and will the compressor be applied across all 4 inputs? Whats the Setup steps

A: Yes, if you connect a compressor to the 1/4" insert of the Radial Engineering KL-8 Rackmount Keyboard Mixing Station, it would be applied across all four (4) input channels.

Q: 7. Does this feed though phantom power?

A: According to the Radial manual: Although the DM1 may work in some cases with condenser mics, we do not recommend it due to power on/off transients which could cause the sound system to pop when switching. To be safe, only use the DM1 with dynamic mics.

Q: 8. What are the dimmentions of the unit? Radial Keylargo

A: The dimension of the Radial Engineering Keylargo as published on the manufacturer's website are: 8.4 x 5 x 1.9 .

Q: 9. Work with dynamic microphones?

A: Yes, dynamic microphones can be used with the Radial Engineering JS-3.

Q: 10. Can this be used to convert a headphones level signal (DDJ 800) to a pro line level signal (+4dBu)?

A: The Radial Engineering StageBug SB-6 Isolator is not converting or boosting line level signals, but rather converting impedance (Hi-Z to Lo-Z) and eliminating hum in the signal chain.