This Cowboy Handle for DSMC and DSMC2 Cameras - Rightfor the right hand features a walnut wood hand grip with nature themed tooling that provides texture for improved grip. The handle is designed to work with both DSMC and DSMC2 RED DIGITAL CINEMA cameras. It incorporates a RED compatible rosette for articulation adjustment and mounts to your camera via a mounting Bracket. The bracket attaches to your camera using the two included mounting screws, and it features a screw slot so you can adjust the position of the handle relative to the camera.

Walnut Hand Grip    Decorative Texture Improves Grip    Rosette Provides Non-Slip Articulation

The handle attaches to your camera's accessory mounting screw holes, allowing you to adjust the position and orientation of the handle to suit your needs

Once attached, you can loosen the rosette and adjust the orientation of the handle

The wood hand grip is made from walnut, which is both durable and attractive

The wood hand grip stays cooler than metal hand grips in hot conditions and doesn't get as cold as metal does in cold conditions

Related Questions and Answers

Q: 1. Hello ! Does this fit on KipperTie Chinstrap mount support ?

A: The KipperTie Chinstrap Support comes with side support ribs with two M4 threads that seem to line up with the Wing Grip's M4 mounting points. It would be best to reach out to KipperTie since B&H does not carry their products.

Q: 2. Is it compatible with the Komodo Outrigger Handle?

A: The Outrigger Handle is designed specifically for its optimal operation. This would not fit within that design and dynamic purpose.

Q: 3. I'm guessing this does not work for DSMC3 cameras such as the new Red Raptor. Is there any way to make it work/what is a good alternative?

A: Unfortunately the RED DIGITAL CINEMA DSMC2 Side Handle is not compatible with RED DSMC3 cameras like the RED V-Raptor. Since the V-Raptor does not have a dedicated R/S trigger handle, you can take advantage of the EXT port and rig a 3rd party accessory to control R/S.

Q: 4. Can I install this over existing Komodo cage ribs or do I need to remove the ribs to install these?

A: The RED DIGITAL CINEMA KOMODO Wing Grip is designed to be mounted directly to the right side of the Komodo.

Q: 5. If you use two of them does it make it 15mm Studio compatible?

A: Yes. The unit does make it 15mm rod compatible.

Q: 6. Are there mounting holes on the bottom for attaching a quick release plate? Or do you have to use it with a Tilta dovetail?

A: There are two 1/4" and one 3/8" threads on the bottom along with the Arri style clamp. Pro tip. The Arri style baseplate and dovetail can be tricky to mount and slide. Do NOT apply oil or any lubrication. This will only gather dirt and make the sliding worse. Instead, make sure the pieces are scrupulously clean. Then it will work as intended.

Q: 7. Is the rosette ARRI compatible?

A: No it is not.

Q: 8. Can this handle also replace the grip on the Komodo Outrigger Handle?

A: No it can not.

Q: 9. Will this work with the Epic-M Dragon 6k?

A: Yes it will.

Q: 10. Will this work on top of the camera to use easy rig

A: The RED DIGITAL CINEMA KOMODO Wing Grip is for side use only.