Use the CAMVATE 15mm Micro Rod with 1/4"-20 Threads & Adaptersfrom CAMVATE 15mm Micro Rod with 1/4"-20 Threads & Adaptersas a versatile camera rig or cage component. This 2" 15mm rod provides a 1/4"-20 female thread on each end and includes male screw adapters for both ends. Two knurled black 1/4"-20 locknuts are included for attaching the blind screws to the aluminum alloy micro rod.

1 x 2" 15mm Rod    2 x Female 1/4"-20 Threads    2 x Knurled Black 1/4"-20 Locknuts    2 x 1/4"-20 Blind Screws    Aluminum Construction

Related Questions and Answers

Q: 1. what is the distance between the screw points?

A: The Tilta 15mm Rod Holder to Dual 1/4"-20 Screws adheres to industry standards thus the screws are 1" on center.

Q: 2. Would this work with the Sony Z280?

A: Yes, the SONY PXW-Z280 would be supported by the CAMVATE Shoulder Mount Rig with Manfrotto QR Plate & 15mm Rod System.

Q: 3. Is there a locking pin on the quick release?

A: There is a button on the side that is required to be pressed to release the plate from the receiver of the quick release, on the CAMVATE Manfrotto-Type Quick Release Baseplate with 15mm LWS Rod Support.

Q: 4. What is the diameter (in mm) of these tubes?

A: Each individual part from the RigWheels 6" Stand-Offs with 1/4"-20 Threads (Set of 4) (B&H# RISO14X64PC) is 6" (about 15.2cm) long and about 2/3" (16.7mm) in diameter.

Q: 5. Is there a warranty on this unit?

A: There is no warranty listed for this CAMVATE V-Lock Battery Plate with Power Supply Splitter.

Q: 6. why does this stick up? What's the purpose of the top part?

A: The Anton Bauer Micro Cheese Plate with 15mm Rod Clamps is positioned vertically to remain parallel and flush with an attached camera body. The top bar can be used to attach additional accessories or non Anton Bauer Micro Plates.

Q: 7. how do i get this on to a tripod?

A: You can either use a tripod that is compatible with the Manfrotto-Style Quick Release Plate or attach a tripod plate to the bottom of the CAMVATE Manfrotto-Style Quick Release Plate with 15mm Dual-Rod Clamp Base.

Q: 8. I'd like to try this with a Tascam DR-05 recorder. The recorder is light, but only 2 inches wide. Does this clamp close enough to hold that?

A: David, the clamp doesn't close it will only stretch open. Hope this helps. It is a good adapter for my iPhone 7 Plus.

Q: 9. Will this allow me to install a light mount, specifically a Godox S2, onto a standard tripod which has a QR plate with 1/4 x 20 threads?

A: Yes.

Q: 10. Does it fit on a tripod?

A: On a tripod head, yes, via the 1/4-20"screw.