Add padded protection to the interior of your Nanuk 909 case with this Multilayered Cubed Foam Insert. Simply place the foam pieces in the case, put equipment on top, mark gear outlines, and remove pick-and-pluck cubes as required. The insert consists of a convoluted piece for the lid, a protective base pad on the bottom, and a prescored cubed layer for the middle. When measuring the gear to the case and removing the cubes, make sure to leave two inches around the perimeter to guard against side impact.

For 909 Case    Three-Layer Design    Prescored Removable Cubed Layer    Convoluted Foam Pad for Lid    Protective Base Pad

Related Questions and Answers

Q: 1. Are the dividers as picture on your website, or are they fabric with the red straps as is pictured on the Nanuk website for the same item?

A: The dividers are exactly like the photo on the B&H website.

Q: 2. Where are they made?

A: This case is made in Canada.

Q: 3. would this case hold larger camera bodies and lens if I lay the bodies down flat along with the lens?

A: I think so, but not many of the larger bodies/lenses will fit. I have a Fuji XT1 and three lenses, plus filters, 5 spare batteries, and various other bits, and they all fit fine. I got the padded inserts rather than the foam. I highly recommend this case, or a bit larger one from Nanuk. It's a pleasure to use.

Q: 4. Will this case fit a Sony A7Sii?

A: Hi, yes, this case can be used for an A7s II.

Q: 5. Can this fit a Sony a7siii?

A: Yes a Sony A7siii does fit in this case.

Q: 6. Is the foam cubed that I need to cut out or is the foam cutout the way it shows in the picture?

A: The foam is pre-cut into the configuration shown in the images. For the standard cubed foam configuration, please see https://bhpho.to/363A8N4

Q: 7. Aside from the base foam and the lid foam, how many layers of cubed foam are in this case and what is the depth/thickness of each layer?

A: There 2 layers of foam that are each 2 inches thick.

Q: 8. Would this box fit a Sony FX6 and FE 24-105mm f/4 G OSS Lens?

A: No. Following unit is designed and made for the Sony a7R system.

Q: 9. Will this fit a DJI Air 2S Drone and controller? I am concerned about the depth.

A: It will be a tight fit with the DJI RC-N1 Remote Controller provided with the DJI Air 2S Drone to fit in the Nanuk 910 Hard Utility Case with Foam Insert (Orange) when it is right side up. The foam will press the DJI RC-N1 Remote Controller. An alternative case to consider is the Nanuk 915 Hard Utility Case with Foam Insert (Orange). See the link below: https://bhpho.to/3wtxQms

Q: 10. will this work for DJI Mavic air fly more package?

A: I do not believe all of the accessories included in the DJI Mavic Air 2 Fly More Combo would fit inside the Nanuk 909 Hard Utility Case with Foam Insert (Black). While many of the accessories should fit, all may not be compatible Instead, I would recommend the Nanuk 915 Waterproof Hard Case with Insert for DJI Mavic Air 2 Fly More Combo (Black), B&H # NA915MAVIA21, for use with the DJI Mavic Air 2 Fly More Combo, which should fit all the accessories included in the kit.