Use this Wooden Camera Screw Set for Director's Monitor Cage v3to connect components to the Director's Monitor Cage v3 from Wooden Camera. The set includes eight 1/4"-20 x 1/2" socket button head screws, four 1/4"-20 x 3/8" socket button head screws, one M2.5 x 4mm socket cap screw, four each of the M3 x 8mm and M3 x 12mm pan head Phillips screws, two #4-40 x 1/2" socket cap screws, one 1.5 Allen wrench, and one 5/32 Allen wrench.

For Director's Monitor Cage v3    Full Screw Set for Cage Components    Socket Button and Phillips Pan Heads    Two Allen Wrenches

Related Questions and Answers

Q: 1. Is this a 1/4-20 thread or 3/8 ?

A: The thread on the Wooden Camera C-Stand Locking Screw for Director's Monitor Cage v2 is defined as a 1/4 20".

Q: 2. Could this fit the SmallHD Cine7 monitor with the SmallRig cage for added protection?

A: Yes it can.

Q: 3. I know it states that it supports some Atomos monitors, but it did not say specifically if it supports the Atomos Ninja Flame 7”

A: Yes, the Wooden Camera Director's Monitor Cage v3 will support 7" displays like the Atomos Ninja Flame.

Q: 4. Can this fit the Hollyland Mars 4K?

A: Yes, the Hollyland Mars 4K Wireless Video Transmission System can be mounted to any of the many mounting points that are all over the Wooden Camera Dual Director's Monitor Cage v3.

Q: 5. does the teradek bolt 4k fit in it?

A: Yes, Teradek Bolt models will fit and work with the Wooden cage. See this image of a Bolt mounted on the cage. https://bit.ly/3tDvTmO

Q: 6. Can we mount iPad using iPAD cage?

A: The Wooden Camera Director's Monitor Cage v3 with Dual Carbon Fiber Handgrips is meant to be used with a professional monitor and will not work with an IPAD.

Q: 7. Does this work properly with the new Atomos Shinobi 7"?

A: This is not a form-fitted cage, but it will work with the Shinobi 7.

Q: 8. Does this come with the swing away bracket and 15mm rods?

A: Yes it includes a swing away bracket.

Q: 9. Is there a particular Baby Pin stud that works really well with this receiver? It always kind of loose even with the tightening screw.

A: The Wooden Camera Director's Monitor Cage v3 with Dual Carbon Fiber Handgrips mainly lists acceptance of general 5/8" baby pins. Ensure that the screw is latching onto the grooves of a 5/8" baby pin.

Q: 10. The c stand mount does fit but it is very loose, is there a way to tighten this?

A: Yes. The following unit will adapt the following mounting points 1/4"-20 Threads Baby Pin 15 mm Rod Clamps Always make sure that the T-screws are in place and fastened tightly.