The Pyle Pro PDIW65 6" 2-Way In-Wall Speaker Pair features two indoor speakers that can be mounted flush in either the wall or ceiling. The PDIW65 is perfect for playing music or voice and features 200W of power and 4-8 Ohms of impedance.

2-Way Speaker System    In-Wall or In-Ceiling Mounting    200W    4-8 Ohms

6" 2-Way In-Wall speaker

4-8 Ohms

200W

Related Questions and Answers

Q: 1. Will these stands work with Dynaudio LYD 48 monitors?

A: While the Pyle Pro Universal Monitor Speaker Stands (Pair) can support the weight of the Dynaudio Acoustics LYD 48 monitors, the footprint of the speakers are much larger than the platform attached to the stand. It may not be the most suitable for speakers that large in size.

Q: 2. Weight capacity?

A: these stands can support speakers of up to 90 lbs each.

Q: 3. Do these speakers get hot when in use? Can I place insulation directly on top of them? Please advise of any concerns in this regard. Thank you!

A: These speakers have a very tone for their size and price. I have a bunch of the installed in our classroom for a couple of years now, and have never experienced heating or performance degradation.

Q: 4. What is the diameter of the speaker mount post?

A: The posts are a standard 1 3/8" diameter.

Q: 5. How long can the arm extend from the wall?

A: The arm on the Pyle Pro PSTNDW15 Dual Universal Adjustable Wall Mount Speaker Bracket Stands can extend to 12.5" from the wall.

Q: 6. Could two of these speakers be connected in parallel to a 4 ohm mono amp?

A: When conecting two of the Pyle Pro PDICRD 5.25" In-Wall/In-Ceiling 150W 2-Way Stereo Speakers (Pair, White) to a 4Ω amp, they should be wired in series to maintain an appropriate load.

Q: 7. what's the screw size used to connect the top plate?

A: The screw is 1/4-20 x 1

Q: 8. what amplifier would work well for running 2 sets of these?

A: Any stereo amplifier with power rated at 4 ohms load, and with connections for two sets of speakers. Or, any cheap Home Theater receiver, with one set connected as front channels, and other set as back channel, and surround mode set to All Channel Stereo , or 4 Channel Stereo . In speaker setup set center channel and subwoofer to none . Since it is multichannel amp, Home Theater receivers don't need to be capable of driving 4 Ohms loads.

Q: 9. if theses speakers were enclosed within a cabinet, what would be the box dimentions, wideth, height, and depth ?

A: These speakers are designed to operate properly in an in-ceiling installation. They should not be set into a baffle or enclosed box.

Q: 10. Im looking at installing the PDIW67 in the same room as the PDIW62 6.5. From the outside do the grills and surrounds look the same?

A: They do not look the same. The PDIW67 is larger and has a thicker grille.