Blonder Tongue Catv Modulator Saw Filtering Channel 50

Product Code: eq70242
Availability: In Stock

$449.85 $647.78

Qty

1 reviews Write a review

Description
Reviews (1)

The Blonder Tongue CATV Modulator SAW Filtering Channel 50from Blonder Tongue CATV Modulator SAW Filtering Channel 50is an all-solid-state audio/video modulator that provides a modulated visual and aural RF carrier output on one specific CATV channel. The unit modulates the audio and video inputs and provides the requested RF CATV channel output for use in a CATV, MATV or SMATV system. The modulator accepts standard (sync negative) polarity video at a 0.7-2.5V peak to peak level from sources such as a TV camera, video tape recorder, TV demodulator or satellite receiver.

The modulator features a +55dBmV RF output level, and an IF SAW filtering for adjacent channel operation. All aeronautical channels are offset positive with a tolerance of ±5kHz as required by FCC 21006. All level controls are located on the front panel. The RF level control provides up to +55dBmV output. The video modulator control sets the depth of modulation for 87.5% over an input video level range from 0.7VP/p to 2.5VP/p. An audio modulation control permits adjustment for ±25kHz peak deviation of the aural carrier.

RF Specification
Frequency Range	CATV channel 50
Output Level	55 dBmV, minimum
Output Level Range	15 dB
Audio/Video Carrier Ratio Control	-7 dB to -20 dB
Frequency Tolerance	±10 kHz standard channels, ±5 kHz FCC 21006 offsets
Audio Carrier Frequency Setting	±1 kHz maximum, 4.5 MHz above video carrier
RF to Video Response	1 dB P/V from Fv -0.5 MHz to Fv +4.2 MHz
Broadband Noise	-90 dBc
Spurious Output	-60 dBc in 50 to 860 MHz Range @ +55 dBmV output
Output Match (Return Loss)	12 dBc
Vestigial Sideband Response	@ channel edge -20 dB, @ adjacent channel -40 dB
Video
Input	0.7 to 2.5 V peak to peak for 87.5% modulation
Input Return Loss	18 dB
Carrier-to-Noise Ratio	62 dB in 4 MHz bandwidth
Hum Ratio	60 dB peak to peak video to 60 Hz RMS
Differential Gain	5% at 87.5% modulation
Differential Phase	5° at 87.5% modulation
Group Delay	170 ±50 nS
Audio
Input Impedance	10 kΩ, unbalanced
Input	140 mV RMS for 25 kHz peak deviation
Frequency Response	±1.0 dB (50 Hz - 15 kHz referent to standard 75 msec pre-emphasis)
Intercarrier Stability	4.5 MHz at ±5.0 kHz
General
Power Requirements	105 - 130 VAC, 60 Hz, 10.5 W
Temperature Range	0 to +50°C
Connectors
Audio In	F-type female
Video In	F-type female
RF Output	F-type female
RF Output Test	F-type female -30 dB
AC Outlet	Female AC outlet 600 VA maximum
Mechanical
Line Cord	6' power cable: 3 wire grounded, 3 wire convenience outlet
Dimensions	19 x 1.75 x 3" (48.26 x 4.44 x 7.62 cm)
Weight	4 lb (1.8 kg)

Meets FCC docket 21006 aeronautical frequency offset requirements

Fully compatible with BTSC encoded stereo audio

Front panel accessible level controls for easy set-up and adjustments

AC outlet

Related Questions and Answers

Q: 1. Can the feet of this Photo Clam MINI50 tripod be replaced with the Gitzo GSF50 50mm Big Foot with 3/8"-16 Accessory Thread?

A: No, this is the replacement feet for the Photo Clam MINI50 tripod: https://bhpho.to/2QqcEJI

Q: 2. Will this device convert OTA video and audio signal to HDMI video and audio output?

A: Yes, the Thor QAM CATV RF and ATSC RF to HDMI Decoder Set-Top Box is designed to convert over the air video and audio signals into HDMI as well as output audio.

Q: 3. Can I use the HPC-12 to combine in-ear monitor transmitters into one antenna?

A: So that we may best assist you, please email us at provideo@bhphoto.com.

Q: 4. Would this work with Altice/Cablevision? Any idea?

A: No, The Thor QAM CATV RF and ATSC RF to HDMI Decoder Set-Top Box will not work with any cable TV service as cable TV QAM is encrypted. This unit works with clear QAM or off-the-air ATSC antenna signals.

Q: 5. Will this grid fit the Broncolor 30 x 180 cm Softbox (11.8 x 70.9")?

A: Although this Profoto RFI series grid has not been tested with the Broncolor 30 x 180 cm Softbox, there is a compatible grid option with the Broncolor 40° Soft Light Grid for Softbox (1 x 5.9'), BH # BRSGSB159 https://bhpho.to/3GLCD6E

Q: 6. Will this grid fit on the 1x6 Profoto RF softboxes?

A: The Profoto 50 Degree Softgrid for 1.0 x 6.0' RFi Softbox, B&H # PRSGR16, would be compatible for use with the Profoto RFi 1.0 x 6.0' Softbox, B&H # PRSBR16.

Q: 7. do you have ex-stock for 2 units ? If not what is the lead time for this ?

A: We do not have this product in stock. This is a Special Order Product that is dropped shipped to you directly from the manufacture 7-10 business days after the order is placed.

Q: 8. Am I understanding this correctly--the PreSonus Studio Channel has a compressor, but does NOT have a Noise Gate? Meaning that noise gets increased in volume as well? Thanks.

A: Correct, there is no noise gate or expander in the Studio Channel. Compressors don't increase level (or noise), they only decrease or limit dynamic range. If you don't have your input gain set correctly, that will decrease your signal-to-noise ratio. If you apply compression to a noisy signal, that noise will seem louder because you've brought the input signal peak and noise floor closer together by compressing the dynamic range of that original signal. Hope that helps!

Q: 9. Can this console be used to control only incandescent stage lights (old school)?

A: The CHAUVET DJ Stage Designer 50 24-Channel Dimming Console is a tree pin DMX control board. To control incandescent lights you will need dimmer packs. As is it is fine for led lights.

Q: 10. Does the composite video output have captioning embedded?

A: The Thor QAM CATV RF and ATSC RF to HDMI Decoder Set-Top Box support Teletext and DVB subtitles for captioning on the outputs.