The black Magenta HDMI 2.0 Active Optical Cable 82ftprovides a simple yet powerful solution for extending high resolution over long distances. This plug-and-play HDMI 2.0 cable supports up to 4K60 4:4:4 with no compression or latency up to 82' and without the need for external power.

Simple 4K60 4:4:4 Extension    EDID Support    No External Power Required    HDCP Support

No external power required

Plug & play

4Kp60 down to 480i supported

No signal loss

EDID support

HDCP support

HDMI 2.0

Related Questions and Answers

Q: 1. I bought this a few months ago. unfortunately did not have to use it until now. When I plug it in to the computer , the software does not recognize the camera. it doesn't know the camera was just plugged in. However, if I use only the USB cord that came with the camera it works. What is going on ? I have a Canon 5D-MII and using Canon software that came with the camera to tether.

A: I use this cord with a nikon D610 and if it is detached during capture I will have turn off the camera and the capture software plug the cord back in the start the Nikon capture software then turn on the camera after the program is up. you could try testing the cord on another camera.

Q: 2. Can I use this with USB 2.0 Mini-B 8 pin Tether Cable? (B&H#TECU8015ORG)

A: Yes

Q: 3. Will this work with the Canon Rebel T7?

A: This Tether Tools TetherPro USB 2.0 Active Extension Cable (16', Orange) is an extension cable. It does not plug into the Canon Rebel T7. The compatible cable that will plug into that camera is the Tether Tools TetherPro USB 2.0 Type-A to 5-Pin Mini-USB Cable (Orange, 15') BH #TECU545. https://www.bhphotovideo.com/c/product/845393-REG/Tether_Tools_CU5451_15_4_6_m_TetherPro.html

Q: 4. Can a cable of this length power devices that work off of bus power? For example, could I use it to connect a keyboard or mouse to a computer?

A: A cable of this length will be just fine as long as it's an active extension cable. This cable in particular will be able to support a mouse, keyboard, and even portable hard drives.

Q: 5. Will this work with the older Decklink 4k Extreme?

A: The Blackmagic Design Decklink HDMI 2.0 & Optical Fiber Mezzanine Card for Decklink 4K Extreme 12G is only compatible with the DeckLink 4K Extreme 12G.

Q: 6. Will this work with a Nikon D850?

A: The Nikon D850 does not have a full USB port on the camera body. The TetherPro USB 2.0 Active Extension Cable (16', Black) would not work as the USB is full sized and not mini USB.

Q: 7. So is this card HDMI 2.0 not the same card as the one bundled with the latest DeckLink 4K Extreme 12G listed as HDMI 2.0b?

A: Yes, The Blackmagic Design Decklink HDMI 2.0 & Optical Fiber Mezzanine Card for Blackmagic Design is the card included with the DeckLink 4K Extreme 12G Capture & Playback Card bundle.

Q: 8. Does this cable support high refresh rates above 60Hz?

A: This cable is capable of 8k 60Hz. At lower resolutions it should be capable of higher speeds. We do not do cable testing for speeds.

Q: 9. When I use this cable with the AVer TR333 v2 camera, the camera keeps disconnecting on the laptop/desktop. Any ideas why?

A: Due to the length of the cable and the fact that it is strictly bus powered, this is likely the result of drawing too much power from your computer's USB port. A powered USB hub such as BH #XCSH43H1HC2 may solve the problem if this is the case.

Q: 10. ?will it work with d300

A: You will need the USB connector that came with the D300 but yes it will work. In order to tether you may need to remove the memory card. Haven't had to tether with the D300 in a while but the D800 is like that when using shooting software like CaptureOne