The rugged Baby to Junior Receiver Adapter | Impact Solutionfrom Baby to Junior Receiver Adapter | Impact Solutionallows you to mount fixtures with Junior 1 1/8" pins on any steel stand, such as a C-stand, that has a 5/8" Baby pin tip. The dual 5/8" and 1 1/8" receivers are constructed with rugged precision-forged steel for secure mounting. Both receivers feature large, ergonomic metal T-handles for a secure grip and tightening.

Combines Baby and Junior Receivers    Solid Steel Construction    Ergonomic, Metal T-Handles

When you need to mount a Junior pin-equipped light fixture but you're using a C-stand, don't leave what you're doing to look for another light stand. Just insert the ME-130 adapter onto Baby pin tip of the C-stand to receive the Junior pin.

This adapter is constructed with a pound of precision-forged steel so you can mount heavy Baby pin fixtures with the confidence that the mount will be secure. Solid steel construction offers more durability than welded products.

Large, all-metal, ergonomic T-handles on both receivers let you get a firm grip for tightening and creating a snug and secure mount for your gear.

The tapered receiver channel design allows secure mounting of irregularly sized pins and studs.

• Light stands with Junior pins
• Light fixtures and accessories with Baby pins

Related Questions and Answers

Q: 1. Whats the load capacity?

A: The manufactures in general do not list the support weight. The estimate is around 15-20 lbs. But they all recommend using a safety cable. This is a link to some of them, https://bhpho.to/3xKi5bo .

Q: 2. This is close to what I need. Is there anyone that makes a 1 inch receiver to 5/8" stud?

A: No, the following unit does not come in a 1inch.

Q: 3. Are all the pieces, including handle metal? If so steel or Aluminum?

A: Yes, they are steel.

Q: 4. Is the junior pin the same length as the Avenger adapter? The Avenger adapter is too long to fit in Matthews 4.5 grip heads.

A: I think there are different lengths. Technically the Junior designation is only about the diameter

Q: 5. How deeply threaded is the female side of the mount / how far do the threads go inside the mount?

A: The top thread is just over a 1''.

Q: 6. Is this adapter threaded on the female end?

A: The female end is an non-threaded 5/8" female receiver.

Q: 7. What's the spec and what's the spacing measurement between those holes?

A: This monitor arm would have a VESA mount of 3 x 3 (75 x 75mm) and would have a step up plate to allow you to use it on a VESA mount of 4 x 4 (100 x 100mm).

Q: 8. Will this fit on source four mini yoke mounting hole?

A: It will fit a mounting yoke for a source four mini.

Q: 9. Can I use this with a Matthews turtle base?

A: Yes, the Matthews Turtle Base can accept this Kupo Junior Stand Adapter.

Q: 10. Can this rotate to alternate between mounting the monitor vertically and horizontally without an extra adaptor?

A: Hi,If you place it on top of a stand with a baby mount you will not need anything else to mount the arm and monitor. If you mount it on the side using a clamp system you may need a few more accessories as you will have to worry about clearance with the monitor.I hope this helps.Regards,Will H