The 66' Magenta Active Optical DisplayPort 1.4 Cable 66ftfrom Magenta Active Optical DisplayPort 1.4 Cable 66ftprovides a simple yet powerful solution for extending high resolution over long distances. This plug-and-play DisplayPort 1.4 cable supports up to 8K at 60 Hz and 4:4:4 color, with no compression or latency and no need for any external power.

No External Power Required    Plug-and-Play    HDCP Support    Supports up to 8K Resolution

No external power required

Plug-and-play

Supports up to 8K resolution (60 Hz, 4:4:4 color)

No signal loss

EDID support

HDCP support

DisplayPort 1.4

Related Questions and Answers

Q: 1. Westcott says this modifier is not to be used with a strobe's modeling light on. It is understandable that leaving a 250 watt modeling light on inside this modifier's closed structure would be dangerously hot, but would it be unwise to use a 250 watt modeling light **even briefly** for the purpose of aiming the focused spot?? It I were to buy this I would want to be able to use my modeling light at least briefly to be able to aim the small focused spot of light on the small products I shoot.

A: Following unit adapt to any Bowens mount system.

Q: 2. Does this cable support high refresh rates above 60Hz?

A: This cable is capable of 8k 60Hz. At lower resolutions it should be capable of higher speeds. We do not do cable testing for speeds.

Q: 3. Is there anyway to adapt this system for Profoto OCF?

A: The following item will mount to Profoto system.

Q: 4. HDMI 2.1 supports 5K@60hz, does this adapter support 5K?

A: The Monoprice DisplayPort 1.4 to 8K HDMI Cable (10'), B&H # MODP148KHC10 will support a 5K monitor.

Q: 5. 3rd party spots that look exactly the same (except front lens) have a conus shaped tube with some optical element after the mount thus it makes it impossible to use it with strobes with protruding bulb like Godox AD600 pro. Does this one have enough space to fit the bulb from 600 pro in?

A: Yes, the Westcott Optical Spot by Lindsay Adler for Bowens works with the AD600 pro. The spot is large enough for the bulb.

Q: 6. At least 3 times this ad says that this modifier is for strobes up to 600 watt seconds. My studio uses Paul Buff 640 watt second Einstein strobes, which are obviously over the stated 600 watt second limit. Should I assume that it would be unwise to use this modifier, fitted with a Bowens to Balcar mount adapter, with my Einstein strobes?

A: This kit is safe to use with monolights that are 600 watt/sec or below.

Q: 7. How does it focus?

A: The 150mm f/3.5 lens included with this kit would have a manual focus ring in front.

Q: 8. Is there video input through these as well? Especially on an HP 840 g1 ?

A: No, this adapter is designed to convert a Displayport port on a computer to HDMI for output alone.

Q: 9. Is this cable compatible with Apple Studio Max

A: The Apple Mac Studio does not have DisplayPort outputs, so the IOGEAR DisplayPort 1.4 Male Cable would not be able to connect to it.

Q: 10. What would be the best source for additional Canon EF lens to use with the Optical Spot?

A: If you own Canon EF mount lenses, 50, 40 or 35mm prime lenses will create a wider spread than the 150mm lens provided with the Westcott Optical Spot by Lindsay Adler for Bowens.