The black Countryman E6 Directional Earset Mic for Lectrosonics Transmittersis a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, directional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers medium gain for very loud speaking, such as in theater performances and most vocals. Additionally, the earset comes with two pattern-changeable protective caps for maximum isolation and gain before feedback. This directional E6 earset's cable terminates to a 2.5mm waterproof locking connector for direct connection to Lectrosonics WM wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Lectrosonics Transmitters    Headroom for Speaking and Vocals    Detachable 1mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    2 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. The directional earset protective caps adjust the pattern from cardioid to hypercardioid.

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The directional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Will this battery fit on a Canon 80D? The one comment says a 6N will not fit on his Blackmagic video assist monitor which I find odd as the only difference between the LP=E6 & LP-E6N is 65mah of capacity.

A: It has not been tested but there is no technically reason we see why it would not work.

Q: 2. For the 5D Mark III, I found the battery door needs to close for the camera to turn on. How have you used the coupler with the battery door since there is no space for the coupler wire to close the door? Or have you taken off the door, in which case, how did you depress the trigger so that it would recognize the power source and turn on.

A: There is a tiny rubber slot in the front of the camera (on the grip, where the end of your pinky finger sits) that opens up, allowing the dummy battery cable to run out.

Q: 3. Will this work for the edelkrone products?

A: Yes this battery can fit Edelkrone products like the HeadONE.

Q: 4. I do not see a hole for the power cord on the 5D Mk IV - guessing I need to a slight door modification?

A: The opening for the power cord on the Canon EOS 5D Mark IV DSLR Camera is covered by a rubber flap on the edge of the battery door (located on the inner side of the camera grip).

Q: 5. What's the male plug size on the end? 5.5mm?

A: I don't remember. I cut mine off and replaced it with a mate to my 12v power supply. In other words, it doesn't matter. Replace it with whatever you want it to be. Just get the polarity right.

Q: 6. Will this battery work with a Z Cam E2C?

A: Yes, The Zcam E2C camera works with Canon style LP-E6 batteries. The Blackmagic Design LP-E6 Battery will work with the Zcam E2C.

Q: 7. Does it work wit the canon R7? I have one of these and ideally wouldnt want to buy a new one for the r7

A: Yes this will work with the Canon R7.

Q: 8. Maybe I'm an idiot. Trying to update some older Lectrosonic gear. This states for "Transmitter and Receiver" Is this a multiuse antenna?

A: You can either use the Lectrosonics AMM-24 antenna on a Lectrosonics Block 24: 614 to 639 MHz receiver, or you can use it on a transmitter.

Q: 9. will this work in a 6D?

A: Technically yes but you need to remove the door as I don't think it will close with wire there.

Q: 10. Is there a power adapter cable that will allow me to power from a battery pack?

A: The DC Coupler DR-E6 is strictly for use with the Canon AC-E6N AC Adapter. Using the Tether Tools Relay Camera Coupler for Canon Cameras with LP-E6 Battery, BH # TECRCE6 with the Tether Tools Case Relay Camera Power System, BH # TECRUPS110 will allow you to power your Canon camera from a Jupio PowerVault III 2-Port USB & Wireless 10,000mAh Powerbank, BH # JUJPV0310. https://bhpho.to/3svG9xJ https://bhpho.to/3Jh4P2I https://bhpho.to/3emlGmw