Canare Starquad Xlrm Cable 35' With Neutrik Xlrf

Product Code: eq7937
Availability: In Stock

$161.85 $257.34

Qty

10 reviews Write a review

Description
Reviews (10)

The white Canare Starquad XLRM Cable 35' with Neutrik XLRFis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik unisex XLR cable. This cable allows you to switch easily between male and female by sliding housing back and forth. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Parameters
Connector 1	1x XLR 3-Pin Unisex
Connector 2	1x XLR 3-Pin Male
Cable Length	35' / 10.6 m
Number of Conductors	4
Wire Gauge	21 AWG
Color	White
Shielded	Yes
Nominal Impedance	44 Ohms
Conductor Capacitance	46.0 pF/ft at 1 kHz
Packaging Info
Package Weight	1.45 lb
Box Dimensions (LxWxH)	7.7 x 7.6 x 1.7"

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. Is there a way to tell the difference between the 2 groups of wiring on each end?

A: There should be markings on each set of connectors that allow you to differentiate between the two different groups on the Canare 4S11 Speaker Cable with 4 Banana to 4 Banana Connectors.

Q: 2. where is this cable made?

A: It is made in Japan. Great quality.

Q: 3. Does the cable itself say made in Japan or China?

A: This Cable is made in Japan.

Q: 4. Are the connectors Neutrik X or the newer Neutrik XX?

A: The product image shows different connectors, depending on the length of the cable. Yet, I received my 25' brown and white cables with newer Neutrik XX connectors, even though the image shows the Neutrik X connectors.

Q: 5. What type of connectors ? Are those Neutrik ?

A: Yes, the L-4E6S Star Quad cable includes Neutrik XLR connectors.

Q: 6. Will this tool work with 1505F or only 1505A?

A: Yes, I have used it on Belden 1505F (the flexible version) with Kings 2065-2-9 BNC connectors. It strips the dielectric a tiny bit longer (and the center conductor a tiny bit shorter) than my personal preference, but the lengths work just fine and are within the tolerance of what the connector can handle.

Q: 7. are these cable ment for mics or are they suitable for studio monitors krk rokit5?

A: Hi Estuardo: Your speakers and cables are good products, and unlikely to be the problem. There is a known noise issue associated with your speakers. It's not serious, but you will need to troubleshoot to find the source. On YouTube search: Fixing Noise Issues w/ KRK Rokit5. There are several videos that should help.

Q: 8. Does the cable itself say made in Japan or China?

A: The cable is labeled MADE IN JAPAN in white directly on it.

Q: 9. Is this item a single cable or a pair of cables?

A: The Canare 4S11 11GA Star Quad Speaker Cable is a single cable that has two banana connectors on each side.

Q: 10. Is this connector compatible with Clear-Com?

A: Unfortunately no. This item BH #NENC6FXB is not compatible with anything. If what you are using outputs 6-pins then this connector would need to be soldered to the intended wire that same configuration. It will not just plug into an existing unit.

ElectricTommy	22/09/2024
[44 Ohms] Good Cabling 5

Elvis	16/09/2024
[1.45 lb] This is a review of the 6 foot Canare L-4E6S Star Quad XLRM to XLRF Microphone Cable. I'm currently using these with the Zoom F3 and Rode PSA1+. It will also be used for portable recording. It's very flexible (though I have no other XLR cables to compare it to.) You can coil it into a 3 diameter round circle without difficulty. It does fit into the clamps on the PSA1+, but I think a thinner cord might fit deeper down in the groove. For a permanent installation, you could probably force it deep down into the groove. The Neutrik nc-mxx connector snaps into the F3 with an elite click. The sound is without any hint of interference. I think the warranty should be longer, but these cables are excellent. 5

ALN	24/08/2024
[1.45 lb] used them from snake to moniter. helped eliminate some buzzzes. 5

Sean	08/08/2024
[21 AWG] Have had the Canare Star Quad cables for years, running from mics, between rackmount gear, and to speakers/monitors. Zero problems: no noise, clicks securely in place, coils up easily for transport. 5

Joe	29/07/2024
[1.45 lb] I've been using the Canare XLR cables purchased from B&H for several years now. I setup and tear down EVERY DAY. Flexibility and lack of noise is excellent especially in rooms where a lot of other electronics are operating. Never a issue with crosstalk. Best of all the colors makes my setup easily repeatable, dependable. and FAST ! Got to love THAT !! Many thanks both to Canare & B&H. Excellent product combined with outstanding availability and service. 5

CJ-TriState	28/07/2024
[White] Everyone knows about the high end/overpriced Mo'Gomi cables! I'll place my money on these instead! Colors, high quality & more at a FAIR price. Plus, the B&H stamp of helpfulness. I'm 100% satisfied! 5

Erik	18/07/2024
[4] I dont have much to say about the cable other than that is it well contructed and carries a good clean sound. I use it with my MXL 870 and Behringer 1204 mixer and I'm pleased with it. 5

pdb	18/06/2024
[21 AWG] no concerns re: cable. fine starquad. just wish it weren't a special order. 5

victoriapio	11/04/2024
[White] Re-cabled everything in a sound room and used these colored cables to keep better organized in the sound rack. They are excellent cables, quiet, and exactly as advertised. 5

Adam	30/11/-0001
[44 Ohms] I'll make this simple: These cables brought my noise floor down, and I'm a little upset I didn't start purchasing them sooner. I used to be a bit skeptical about the importance of cables, but I won't be buying anything else form now on. 5