The purple Canare Starquad XLR-TRSM Cable 3' (Purple)is handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik XLR and TRS Phone connectors. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. Can you transfer data from an external hard drive to computer with this cable?

A: Yes, the RODE SC27 SuperSpeed USB-C to USB-C Cable (Green, 6.6'), B&H # ROSC27G, will allow you to transfer data from an external hard drive to a computer.

Q: 2. Will this work with Belden Snap-N-Seal BNC connectors?

A: These will not work with the Belden Snap-N-Seal BNC connectors.

Q: 3. Is this good for a 5.5 coax canare cable

A: No, the Canare TS100U Coaxial Cable Stripper (5-in-1) does not work with a 5.5 coax Canare cable. You need to use a generic coax stripper.

Q: 4. Is this for one single cable, or a stereo pair?

A: The Canare 4S11 speaker cable can be used for applications with bi-wire and bi-amp configurations where the amplifier has two sets of outputs and the speaker has two sets of inputs which are typically stereo pairs.

Q: 5. Will this tool work with 1505F or only 1505A?

A: Yes, I have used it on Belden 1505F (the flexible version) with Kings 2065-2-9 BNC connectors. It strips the dielectric a tiny bit longer (and the center conductor a tiny bit shorter) than my personal preference, but the lengths work just fine and are within the tolerance of what the connector can handle.

Q: 6. Will this cut RG179 sized coax cabled?

A: I believe the RG179 might be too small to use with the TS100E or TS100U stripper. knowing the manufacture, model number of the coax, & which connector being used would be helpful.

Q: 7. From the picture it looks like there are 2 red and 2 black for the flex braid. How is it distinguish which wire is which from one end to the other?

A: Now I understand your question, no, there are no marking for the pairs, I used a voltmeter to determine the pairs, then labeled it myself.

Q: 8. Is there a way to tell the difference between the 2 groups of wiring on each end?

A: There should be markings on each set of connectors that allow you to differentiate between the two different groups on the Canare 4S11 Speaker Cable with 4 Banana to 4 Banana Connectors.

Q: 9. Is this balanced TRS or stereo TRS ?

A: The Canare Star Quad 3-Pin XLR Male to 1/4 TRS Male Cable is a balanced cable.

Q: 10. What is this cable made in? Thank you in advance.

A: Canare Star Quad cable is made in the United States.