Designed for solid and interference-free outdoor PtP connections, the Ubiquiti AF-11FX Licensed Wireless Backhaul Radio Kitfrom Ubiquiti AF-11FX Licensed Wireless Backhaul Radio Kitbypasses the 5 GHz spectrum to offer full-duplex, point-to-point bridging (two units required for PtP bridging) and carrier-class backhaul network connections over 10.7 to 11.445 GHz bands. The AF-11FX kit consists of the AF-11FX radio, AF-11G35 antenna, and low-band duplexer, which supports a throughput of up to 1.2+ Gb/s, at distances up to 186.4+ miles. The low-band duplexer is reconfigurable and can support low channel 10.7 to 10.955 GHz frequencies, or high channel 11.2 to 11.445 GHz frequencies.. The AF-11G35 antenna is specifically designed for the AF-11FX so that installation doesn't require special tools.

Full-Duplex Point-to-Point Bridging    Carrier-Class Backhaul Connection    11 GHz Frequency Support    Up to 1.2+ Gb/s Throughput    Range of Up to 186.4+ Miles    Powered by PoE or DC Terminal Block    Single SISO or Bonded MIMO Channels    Built-In Rain-Fade Mitigation    Supports Up to 1024QAM Constellations    N-Connectors with Silicone Boots

Can be powered by RJ-45 PoE or DC power
N-connectors for compatibility with other antennas
N-connector silicone boots for weatherproof protection against dust and moisture
Built-in rain-fade mitigation for a more robust link
Can use single SISO or bonded MIMO channels (MIMO requires an additional duplexer)
Different channel width sizes
Independently configure TX and RX frequencies
Supports high-order constellations up to 1024QAM
Antenna is preconfigured with V/H polarization
Antenna can support ± 45° slant polarization for improved noise immunity and SNR (dependent on regulatory region)

Related Questions and Answers

Q: 1. Can I use non Sony (e.g., Nikon) flash with this?

A: As indicated under the Overview for the Sony FA-WRC1M Wireless Radio Commander with FA-WRR1 Wireless Radio Receiver Kit, it is compatible for use with the following Sony Multi-Interface hot shoe flashes:Compatible FlashesHVL-F32MHVL-F43MHVL-F60MHVL-F42AM (manual only, requires ADP-MAA Shoe Adapter)HVL-F43AM (manual only, requires ADP-MAA Shoe Adapter)HVL-F58AM (manual only, requires ADP-MAA Shoe Adapter)As Nikon flashes do not have the extra pin design on the front of the hot shoe as does Sony's Multi-Interface flashes, there would be no extra communication for adjusting output power, zoom, exposure compensation, HSS, etc. If you use a Nikon flash on the above remote, the flash would have to be set to full Manual mode, and you would have to preset the flash output manually on the Nikon flash.

Q: 2. Is this compatible with the Sony a6300?

A: The Sony FA-WRC1M Wireless Radio Commander with FA-WRR1 Wireless Radio Receiver Kit is compatible with the a6300.

Q: 3. Is this a USB-C or standard USB connection?

A: The Ubiquiti Networks Instant 802.3af to USB Adapter BH #UBINS3AFUSB uses a USB Type-A port.

Q: 4. How any watts does this supply?

A: The Ubiquiti Networks U-POE-af PoE Adapter BH #UPOEAF supplies PoE 48 VDC at 0.3 A (Output). Convert amps to watts: (A)*(V) = (W). 48 VDC x 0.3 A = 14.4 watts.

Q: 5. Is this US version or International version?

A: All of the Ubiquiti products (including Unifi and Amplifi lines) sold at B&H are U.S. versions.

Q: 6. Does this work with the sony a9?

A: Yes, the Sony FA-WRC1M Wireless Radio Commander with FA-WRR1 Wireless Radio Receiver Kit would be fully compatible for use with the Sony Alpha a9 Mirrorless Digital Camera.

Q: 7. What PoE injector is required for this device? It's unclear from the specs what it expects.

A: This unit requires an 8.5w PoE budget.

Q: 8. Is this compatible with the Sony A7r IV?

A: Yes this trigger works with the Sony A7R IV.

Q: 9. Is this HD unit compatible with a M/N: AF-5X radio?

A: It is not compatible.

Q: 10. Is this rated for in-wall use?

A: The manufacturer does not specify if the Ubiquiti Networks Instant 802.3af to USB Adapter is rated for in-wall use.