The OZEN Agile 5S S-Loc 75mm Fluid Headis a 75mm half-ball fluid tripod head built for compact, handheld-size cameras. It's designed with 7+0 steps of counterbalance fine-tuned specifically for such small and lightweight cameras. With a counterbalance payload of 0-15 lb, the head supports these cameras with or without accessories. The Agile 5S features OZEN's S-Loc sideload quick release camera plate system, which provides increased front to rear balance adjustment and accommodates front-heavy or back-heavy loads.

The Agile 5S offers 3+0 steps of fluid pan and tilt drag and has independent pan and tilt locks. Drag is designed to be ultra smooth and to remain so through continued use. The "0" setting being available for both counterbalance and drag, the Agile 5S is also highly suitable for still photography.

The head provides two rosette mounts and includes an extendable pan bar that can be attached to either the left or right rosette. The rosettes are replaceable for added longevity of the head. The supplied camera plate comes with both 1/4"-20 and 3/8"-16 mounting screws. An illuminated bubble level is also built in and powers on at the press of a button so you can balance the head in any environment.

Designed for Mirrorless/DSLR Cameras    7+0 Counterbalance Steps, 15 lb Payload    Ultra-Smooth 3+0 Steps of Pan/Tilt Drag    S-Loc Sideload Camera Plate System

• 75mm half-ball fluid tripod head
• 7+0 steps of counterbalance tailored to handheld-size mirrorless/DSLR cameras
• 0-15 lb counterbalance payload
• S-Loc quick release camera plate system
• 3+0 steps of fluid pan/tilt drag designed to be ultra smooth over continued use
• Independent pan and tilt locks
• Two replaceable rosette mounts
• Extendable pan bar included
• Camera plate with 1/4"-20 and 3/8"-16 mounting screws
• Illuminated bubble level
• Aluminum build

Related Questions and Answers

Q: 1. Can the 75mm bowl be removed?

A: you can remove the stud (where you attach the tie down), then it is a flat base

Q: 2. How do you remove the center stud so I can put it on my slider?

A: It should be a simple matter of unscrewing the tie down on the bottom of the head. If you are having issues feel free to reach out to use directly at ask@bandh.com for further assistance.

Q: 3. I see 2 different mid-level spreaders. Does this come with the barrel twist or lever?

A: The OZEN 100CF2HD 100mm Carbon Fiber Tripod uses flip brake levers.

Q: 4. Is the counterbalance up to 8kg?

A: The manufacturer of the Sachtler Ace XL Fluid Head (75mm Bowl) (B&H# SAS21500004) does not list the amount counterbalance weight associated with each setting. However, it would be close to that as a maximum.

Q: 5. What are the dimensions of the pan bar (length and diameter) when full collapsed?

A: The pan bar itself (not the thicker section near the clamp and not the grip handle) of the OZEN Agile 5S S-Loc 75mm Fluid Head (B&H# OZAG5S) is approximately 3/4" (19mm) in diameter. The length of the pan bar including both the thicker section (where it starts) until the bottom end of the grip handle is approximately 15" (38cm) in length when measured from the start, to the elbow bend, and then from there to the opposite end of the pan angled bar.

Q: 6. Can the plate pop in from the top like many manfrotto tripods do?

A: No it can not. It slides in from the back.

Q: 7. Is the base plate Manfrotto 501PL compatible?

A: It will not match the 501PL plate.

Q: 8. What are the dimensions of this handle when fully collapsed?

A: The OZEN Extending Pan Bar (PB-2) The dimensions of the handle are - From the front of the rosette to end of the handle, it is 15” long. The extension adds up to 7 ½” inches to the PB-2’s total length when extended.

Q: 9. Is this compatible with the iFootage Gazelle TC7 Fast bowl tripod?

A: Yes, the Sachtler Ace XL Fluid Head (75mm Bowl) can be used with the iFootage Gazelle TC7 Fastbowl Carbon Fiber Tripod.

Q: 10. Is this good for longer lenses? Around 750mm FF equiv, with a 7kg camera?

A: If the camera and lens has a weight that is within the payload of 17.6lbs, it can be a fine option with appropriate adjustment of drag and counter balance, but the weight of your camera is 7kg/15.4lbs camera without lens. An alternative head consideration that offers a higher payload and continuous drag / counter balance adjustment is Manfrotto 612 Nitrotech Fluid Video Head BH #MAMVH612AHUS • MFR #MVH612AHUS. https://bhpho.to/3ECvKCu