Global Truss 6-Way Corner Block With 2 Sides

Global Truss 6-way Corner Block With 2 Sides

Product Code: eq81014
Availability: In Stock

$1,449.00 $1,840.23

Qty

14 reviews Write a review

Description
Reviews (14)

This Global Truss 6-Way Corner Block with 2 Sidesfrom Global Truss 6-Way Corner Block with 2 Sidesconnects with DT-GP strait truss segments, corners, and connecting bar sets.

For DT-GP Square Trussing System

Packaging Info
Package Weight	37.12 lb
Box Dimensions (LxWxH)	13.9 x 13.9 x 13.6"

Related Questions and Answers

Q: 1. Whats the bolt size?

A: The following size of bolt is a M12.

Q: 2. How much weight can it handle?

A: The capacity of the corner is dependent on the horizontal and vertical span that it will be connected to. How are you using it and how wide and the tall if the truss that it is being connected to? How much weight do you need to load on the truss system?

Q: 3. Is it 8 x 8' include the Truss itself? Or just the space inside of Truss?

A: The Global Truss Mobile DJ Goalie Post Truss System (8 x 8') BH #GLTRSYSTEM has exterior dimensions of 8.25' high x 7.8' wide.

Q: 4. What's the maximum weight this truss can hold with a center load at full 8 foot span?

A: Please contact Global Truss customer support to discuss further.

Q: 5. Can you clarify the 1.64' length? Is each "leg" of the truss 1.64'? Is that from outside corner or inside corner or centerline of truss? I appreciate it. We're drawing up a truss system and have some critical connection points to consider.

A: The length on this Global Truss SQ-4123 F34 Corner is measured from end to end.

Q: 6. Does this truss come with couplers?

A: No. Units are sold separately. Global Truss Double Ended Conical Coupler for F23/F24 Series BH #GLCOUPLERF23 • MFR #COUPLER F23 https://bhpho.to/3rcwLNZ

Q: 7. Do you need any additional hardware to connect this to a f34 truss?

A: The Global Truss SQ-4121 2-Way 90° F34 Square Truss Corner (Silver) only comes with one set of connectors. If you do not have any you will need another set, four of, BH #GLCOUPLER (https://bhpho.to/47xtHjm)

Q: 8. What are the inside dimensions ?

A: As per the manufacture. The inside diameter off that circle is 1,420mm or approximately 4’ 7-29/32”. The truss itself is 290mm or 11-27/64” in width (hence 2,000 – 290 – 290 = 1,420mm). Please note that as this is a welded product these dimensions may vary slightly.

Q: 9. What size pipes will this fit?

A: This clamp will accommodate 2" OD pipe

Q: 10. Can I add wheels to the stand?

A: No. Wheels can be added to the following unit.

Jack Dempsey	23/09/2024
[37.12 lb] Lite, strong, stable, easy and simple to assemble, easy to move and adjust. 5

Jeffrey	07/09/2024
[37.12 lb] I recently mounted my telescope tripod (Celestron AVX) to a wheeled platform (ScopeBuggy) to facilitate moving my telescope between my garage and my backyard. When you're putting an expensive tracking mount, telescope and camera on wheels, you need to make sure there is absolutely no chance of your equipment tipping over. I purchased 3 Global Truss Eye Clamps to use as a means of securing each of my tripod legs to the ScopeBuggy. The clamps install in seconds and fit perfectly on the Celestron AVX tripod legs. They also do not cause any damage to the tripod legs. Once installed, I just wrapped rubber tie downs between the ScopeBuggy frame and each Global Truss Eye Clamp and I was good to go. 5

Rene	04/08/2024
[37.12 lb] I love it. it makes it fast 5

Matthew	27/07/2024
[37.12 lb] I'm not using it for lighting or stage, but rather a ham radio antenna. I bought it specifically to use at the base of a mast pole that I needed to tilt over to where I could reach the top and do some work on it. Using this clamp and a pole pounded in the ground, I was able to tilt the top down without the base sliding away from me. 5

James	16/07/2024
[37.12 lb] The items arrived with box badly torn and damaged but the product was intact and ready for use with no defects! 5

Darlene	15/07/2024
[37.12 lb] High quality and lightweight clamp, great for moving heads or any fixture that you don’t want to use with a c-clamp! 5

Jaron	12/07/2024
[37.12 lb] Great price, strong and light. 5

John	24/06/2024
[37.12 lb] good quality clamp, they are used everyday 5

Chris	21/06/2024
[37.12 lb] The purchase and the timing worked out perfectly thank you 5

Anthony	16/06/2024
[37.12 lb] Bought this adapter for my DT-PRO4000 stands and Global F34 truss. Works great and will adjust for other brands and models of truss. I'd recommend wearing gloves when handling, as they do have some sharp edges. 5