Offered here in a 5-pack and featuring durable stainless steel construction, the CAMVATE 1/4"-20 Screw Adapter 5-Packfrom CAMVATE 1/4"-20 Screw Adapter 5-Packconnects devices such as monitors, tripods, adapters, lights, and accessories with 1/4"-20 female threads.

1/4"-20 to 1/4"-20 Male Adapter Screw    Stainless Steel Construction

Related Questions and Answers

Q: 1. I ordered this and it was not the Right screw for me what is the right one where I can slide it down a mounting bar after threading it in? Something longer.

A: A shoulder screw seems the appropriate fastener if I understand the situation. These have a threaded portion at the end of the shaft and an unthreaded portion beneath the head. The shoulder is formed at the border between the two portions, the unthreaded area being of greater diameter than the threaded. This shoulder allows the screw to be secured in the camera before it bottoms out in the hole. Please try a search for 'shoulder screws' to understand the variety of configurations or visit a good hardware store. The standard 1/4-20 threading applies.

Q: 2. What is the thickness of the plastic knob? I assume that the 11mm spec is the length of the metal screw. I need a spacer to raise a camera a few mm above the tripod mounting plate.

A: 11 mm does refer to screw only. Knob is additional 7-8 mm thick

Q: 3. Can the screw on this plate be replaced with a longer screw?

A: I dont see why the screw cant be replaced as mentioned, but youll have to grab the retaining washer with pliers.

Q: 4. What's is the load capacity ? Thanks

A: The load capacity of the SmallRig Camera Hot Shoe Mount with 1/4"-20 Screw Ball Head is 6.6 lbs.

Q: 5. I have an old 70s Stitz Camera Grip and I broke the screw on the bottom which latches the camera to the bar grip. Is this what I need?

A: I think it will do the job. I got two and used them on different grips and they worked fine.

Q: 6. I have a Rokunar SP Studio System. One of the light stands top has a screw for adding a lamp, the threaded screw broke. I tried to take it off the pole but it does not come off. I did take the screw off that holds it to the pole. It seems to be glued in. Used two pipe wrenches, but it busted. So now I will drill it out or cut below it and lose about 2 inches. So what is the replacement I need?

A: Just get a new one its worth the headache

Q: 7. Hi .. will this plate fit the Manfrotto 290 MT294A3. If not which plate do I need for the 804RC2 dual head. Thank You

A: The 200PL is the correct plate for the 804RC2 head.

Q: 8. Does 14mm length includes the knob?

A: Yes, the 14mm length measurement of the Vello 1/4"-20 Camera Screw - 14mm Long (2-Pack) includes the knob. The length of the screw and the stud alone would be 11mm (0.43 inches) in length.

Q: 9. What is the mm spacing between the two 1/4-20 screws on center?

A: The spacing between the two 1/4-20 threads on the CAMVATE 0B 2-Pin Female 1 to 3 Power Splitter Adapter Box with 1/4"-20 Screw Mount is 7mm. However you can slide the 2nd screw down up too 14mm away from the first screw.

Q: 10. I was wondering what the outer diameter of the black knob is - I'm looking to design a rig and I want to make sure I don't run into a conflict! Thank you.

A: The outer diameter of the black knob is 1.16 .