Run your DMX cables through a wall neatly with the ivory Lexan My Custom Shop 5-Pin XLR Female DMX Wall Plate. It features a 5-pin XLR female DMX connector on each side, so you can run your wiring through a wall for easy connection to your devices.

Single-Gang Design    Locking 5-Pin XLR Female DMX Connectors

Related Questions and Answers

Q: 1. Will this cable work on the Red Raven DC 4 pin power port?

A: Unfortunately this cable is not compatible with that particular power port.

Q: 2. How long is the 4 pin xlr cable, and is it permanently attached to the power brick?

A: The cable is soldiered in and around 5 feet long.

Q: 3. Can this dimmer pack be used with the Altman 70W Star Par CDM Par Light (https://www.bhphotovideo.com/c/product/392139-REG/Altman_SPCA11070_70W_Star_Par_CDM.html)?

A: Yes you can use the Altman 70W Star Par CDM PAR Light with this dimmer pack but you will need to add the Altman Edison Connector, 5-15P - Male, 15 Amps, B&H # ALEC15M to the cable. https://bhpho.to/2OBnePE

Q: 4. Is the plate magnetic? Could the Aputure MC stick to it?

A: The Impact Wall Plate with 3" Baby Swivel Pin is comprised of steel so the Aputure MC can stick to the back of it.

Q: 5. Can these dim LED hi bay fixtures?

A: It depends on the type of fixture you have, if they're dimmable then you can use this dimmer.

Q: 6. Is the top of the pin big enough to attach a grip head? I want to wall mount this with a 40" arm & small light over a table.

A: The Impact Wall Plate with 90-Degree Baby Pin has a standard Baby Pin, just like any light stand, it it is computable with a standard grip head.

Q: 7. Can the phoenix connector be removed and another type installed?

A: The PHOENIX connector on the Hosa Technology PHX-206F-BULK Female Phoenix to 3-Pin Female XLR can be removed and replaced by a different type of connector, if so required.

Q: 8. Will this fit the thread spacing on the bottom of the Decimator MD-HX?

A: This My Custom Shop shelf is a universal solution and should allow you to attach any small converter model to the shelf.

Q: 9. Can I turn the light on and off through DMX? Thanks!

A: Yes, the Litepanels 5-Pin XLR DMX Communications Module is going to allow you to turn a Litepnanels Astra 1 x 1 panel on or off when connected to an appropriate DMX controller.

Q: 10. What size screws do the front port holes use for adapators? I bought TecNec SCREW-38B 4-40 x 3/8" Flat Heads, but they too small

A: The My Custom Shop 16-Port Unloaded Rackmount Panel with Rear Lacing Bar (1 RU) does not have threaded mounting holes, so you will need to use a nut with your screws. The recommended screw is SCREW-38B and the corresponding nut would be the NUT-CMT.