The green Canare Starquad XLRM Cable 35' Greenis handcrafted with the super flexible Canare L-4E6S cable and superior Neutrik unisex XLR cable. This cable allows you to switch easily between male and female by sliding housing back and forth. Use Starquad for reduced hum and EMI, and no handling noise. This cable is perfect for all microphone use and great for connecting balanced output of some audio processors, mixers, and low density patch bays to XLR inputs.

Special cross-linked PE insulation

Hand assembly with true silver solder

Pure performance Neutrik XLR and Neutrik Phone connectors

Related Questions and Answers

Q: 1. is this cable rated to 4.5gHz?

A: We are unable to find a specific rating for that at this time. I just wanted to reach out to you directly regarding your question on our website for this product. So that we may best assist you finding the proper product for your needs feel free to email us directly at askbh@bhphoto.com.

Q: 2. Will this cut RG179 sized coax cabled?

A: I believe the RG179 might be too small to use with the TS100E or TS100U stripper. knowing the manufacture, model number of the coax, & which connector being used would be helpful.

Q: 3. From the picture it looks like there are 2 red and 2 black for the flex braid. How is it distinguish which wire is which from one end to the other?

A: Now I understand your question, no, there are no marking for the pairs, I used a voltmeter to determine the pairs, then labeled it myself.

Q: 4. Is there an easy way to extend one pair of the Canare 4S11 speaker cable an additional 10 feet? My left speaker needs just under 50 feet and my right just under 60 feet.

A: You can try to use an insulated banana plug coupler but it would be best if you use 14 gauge speaker wire at the length that you require.

Q: 5. Does anyone know what the length of the banana plug is? Clearance is tight between the back of my amplifier and the rear of the av cabinet, and these look like long connectors. I may have to go spade to be safe.

A: According to Canare they are #PIN1 pins (.077" wide x .113" high).

Q: 6. How long is it from the end of the banana plug to the jacket? In other words how long are the exposed red and black wires? Thanks.

A: 6 inches.

Q: 7. Will this tool work with 1505F or only 1505A?

A: Yes, I have used it on Belden 1505F (the flexible version) with Kings 2065-2-9 BNC connectors. It strips the dielectric a tiny bit longer (and the center conductor a tiny bit shorter) than my personal preference, but the lengths work just fine and are within the tolerance of what the connector can handle.

Q: 8. Is this pair?

A: The Canare 4S11 Speaker Cable 4 Banana to 4 Banana has two pairs of banana cables wrapped together for a compact setup.

Q: 9. This is a pair or just one cable for one speaker only?

A: This is one cable with four banana connections on each side.

Q: 10. What’s the inside dimension of the spade?

A: The inside dimension of the spade on the Canare 4S11 Speaker Cable 2 Banana to 2 Spade (3') is 2.5mm .