Did you lose the channel knob on your TK-2400V16P, TK-2402V16P, TK-3400U16P, TK-3402U16P radio? Replace it with this Kenwood Channel Knob.

Plastic Knob    Works with TK-2400V16P and TK-2402V16P    Works with TK-3400U16P, TK-3402U16P

Related Questions and Answers

Q: 1. What difference between this one and the DDC-60i model? Thx.

A: Sunwayfoto DDC-60i Screw-Knob Clamp (60mm) has safety stop grooves. Sunwayfoto DDC-60 Screw Knob Clamp (60mm) does not have that feature.

Q: 2. Does the tightening knob head extend below the base level of the clamp? I'd like to attach it to the top of leveling head DYH-66i. It would have to be screwed in by rotating this clamp. Bubble level of 66i does not allow attachment of clamps by rotating them into the center screw if their tightening knob extend below the bottom level of clamp.

A: Yes, the knob drops below the clamp by about 2mm. You can try using a tripod spacer like the one below; https://bhpho.to/39dgYEs or your better off get a clamp that is circular and the knob has clearance or a clamp with a lever; https://bhpho.to/2CGdONl

Q: 3. We have 2 sets of these and would like to use each set independently. Currently if you talk on one it can hear on both. how can we set them?

A: The PKT-23 is a multi-channel transceiver. In order for 2 sets to be used independently, two of the units will have to be assigned to a different channel. Channel setting instructions are listed in the operation manual. Please see the following link: http://bit.ly/1R5W5dK

Q: 4. Are you able to hear incoming calls while around heavy equipment?

A: Yes, you will not have any connection issues when receiving calls around heavy machinery. If you are asking about if the ringer is loud enough for heavy industrial environments, that depends on the ambient noise level of the area.

Q: 5. Can these knobs be used with the Skywatcher extension tube for AZ-EQ5 Pro tripod?

A: I can only advise what Losmandy states: allow users to mount a GM-8 or G-11 equatorial head to a tripod without tools.

Q: 6. Are these radios good for indoor as well as outdoor use?

A: Yes. You are able to use these both outdoor and indoor. Operating conditions:Open areas without obstructions is up to 5 miles (8 km)Residential areas near buildings is up to 1.5 miles (2.4 km)In steel and/or concrete reinforced buildings the range is up to 225,000 sq.ft (20,900 sq.m)The range in high-rise buildings is up to 17 floors

Q: 7. Does it come with screw?

A: No, the Sachtler Tie-Down Knob for Ace & 75mm Heads does not come with screws.

Q: 8. Can you listen to both sources at the same time?

A: No, the Mackie Big Knob Passive Studio Monitor Controller does not allow the combining of both sources to a single output selection. Its "A/B" source select switch requires the user to choose one of the sources at any given time.

Q: 9. Will it work with the Arri 150 Fresnel? I only see the 300 and 650 mentioned in the overview. Thanks

A: Yes it will. Replaced a number of them on my 150s.

Q: 10. Does anyone know if the the Varavon Armor GH4 cage will slide into this?

A: No problem. Perhaps all four edges of the dovetail plate are undercut, I'm not sure from the pictures. If they are all undercut then you could use the sunway clamp or any other clamp with no problem. Maybe if you pose that question to people who have purchased the cage and they could confirm. Regards.