[Black] Bottom line: A versatile and reliable kit to use as an addition to or starter for your C-Stand. Highly recommended. Avenger D520B (40 Extension Arm)performs just as it should to hold lights up to 8lbs., flags, reflectors, and gobos. The black finish will wear the more it's used, but it's a solid piece. Avenger/Manfrotto C1575B (Super Clamp)Super strong! The jaws open up wide to 2.5 and then lock like a bulldog's jaw using the twist handle. It includes a wedge to clamp onto flat surfaces (clips onto the tightening knob for the stud receptor when not in usevery handy). The 1/4-20 female threads in it's base are useful for screwing a stud in there for small lights and extension arms while the 5/8 hexagonal female receiver locks studs and arms in place using a tightening bolt and spring-loaded push pin. Avenger D200B (2.5 Grip Head)Does its job like a champ to hold just about anything that will fit its jaws and female stud receptor. Put this kid onto the top of a C-Stand and tighten it up using the very comfortable rubber grip pads (not shown in pictures). Fits 5/8 studs and stand top as described. Avenger/Manfrotto E600 (Aluminum Snap-In Pin)Does its job as expected, though this guy is a little on the light side and will get banged up easier than the steel versions. The hex end pops into a Super Clamp to stop it from twisting while the opposite end accepts light fixtures with a 5/8 female receptor. Get this kit and get to work!

[0.16 lb] Nice addition to package. The bag is a bit small though. You have to stretch it to fit the grip arm.

[Plastic] 50/5000
very well armed feels strong and very maneuverable

[0.16 lb] A million uses and well made...

[Plastic] I love the all black but more importantly the handles include nice rubber grips.

[Black] It starts here... you can't beat Avenger for quality and strength!

[Plastic] Ever had a hard time trying to get the light into the right position without the light stand showing up in the picture? Love how the grip kit gives you more freedom in placing the modifier right where you need it - placing that hair light just out of frame.

[Black] Very high quality build. I have been able to use this throughout the weekend and found it to make quite a difference in my shooting experience and comfort throughout the day. 

Cons: The thumb screw and the other screw tend to easily collide during initial tightening and you must put some forethought into tightening them both down in sequence. If you want to slide the grip forward or back later it takes some tweaking to be able to loosen and re-tighten.

Definitely a great setup for shoulder mount !

[Plastic] Works smooth with the 28 to 135mm Zoom Lens on the FS7, useless on Sony Vario-Tessar T* Fe 16-35mm F/4 Za Oss and the Sony Fe 70-300mm F/4.5-5.6 G Oss Lens.

[0.16 lb] In time got it