Run your 1/4" cables through the wall neatly with the ivory Lexan My Custom Shop Four Stereo 1/4" 2-Gang Wall Plate. It features four stereo 1/4" connectors on the front and solder terminals on the back, so you can run your wiring through the wall for easy connection to your devices.

Double-Gang Design    4x Stereo 1/4" Ports on Front    Solder Terminals on Rear

Related Questions and Answers

Q: 1. can this be used and still use a tripod? I am trying to use this mount simultaneous with a really right stuff l bracket.

A: Yes, when one is using the Hoodman HCP DSLR Camera Custom Finder Base Plate, for HoodLoupe, one can connect the base plate to a tripod using a 1/4"-20 inner thread in the base plate.

Q: 2. Will it mount to a Sony FX3?

A: Yes, the Hoodman HCP2 Mirrorless Camera Custom Finder Base Plate for HoodLoupe would work with the SONY FX3. Please note that this is just the mount, and it does not include the Hoodloupe. The best choice would be the 3.0" model but that is discontinued. Hoodman HoodLoupe Outdoor LCD Viewfinder for 3.2" Screens BH #HOH32MB • MFR #H32MB

Q: 3. Does it come with a power supply? If yes, do you have a picture?

A: Yes it comes with a power supply. It listed in the 'In The Box' section of the product page on your far right-hand side of the Overview Tab. We do not have a picture of it.

Q: 4. Is this supposed to work with 3.5mm headphones?

A: Yes, each channel has both 3.5mm stereo TRS and 1/4" stereo TRS headphone outputs.

Q: 5. It is too small to fit over the Rode stereo VideoMic Pro's foam. Was it designed to fit over this mic once the foam has been removed?

A: It is not designed to fit over the foam windcover.

Q: 6. can this mount the Blackmagic Micro Converters?

A: Yes, you can use the BLACKRACK-2 Universal Mini Converter Rackmount to mount the Blackmagic Design Micro Converters.

Q: 7. Can the FX4-SDI perform frame rate conversion? I'm interested in converting a 3840x2160 60Hz signal from a computer to Quad Split 1080p59.94 or 1080p29.97

A: Yes it can.

Q: 8. can this be used to mount viewfinder for Nikon d800 on a rig?

A: This will support our Hoodloupe HLPP3M and it will work with a Nikon D800.Rig? It depends which one. Send me a photo.Thanks,Bob

Q: 9. Hi, is this compatible with a Canon 250D? Thank you!

A: The Hoodman HCP DSLR Camera Custom Finder Base Plate for HoodLoupe is made to be a universal DSLR solution and should work fine with a Canon 250D.

Q: 10. Does it have any voltage gain? I'd like something to make an existing headphone output louder.

A: Yes it does. I often run it from the headphone output on my mixer and you do get a reasonable increase in volume when turned right up on the HA43