Run your 1/4" cables through the wall neatly with the white Lexan My Custom Shop Four Stereo 1/4" 2-Gang Wall Plate. It features four stereo 1/4" connectors on the front and solder terminals on the back, so you can run your wiring through the wall for easy connection to your devices.

Double-Gang Design    4x Stereo 1/4" Ports on Front    Solder Terminals on Rear

Related Questions and Answers

Q: 1. Hi, I recently purchased from B&H the HLPP3M loupe and now want the base plate to suit my 800e ... Is this the correct one and will it work with and without the battery base on the camera? ..thanks Geoff (a wish I lived in New York customer so I could see all the goodies in the store)

A: Yes, the Hoodman HCP DSLR Camera Custom Finder Base would be compatible for use with the Nikon D800E DSLR camera both when using the camera with a battery grip or when used with the camera by itself.

Q: 2. Would this fit over a Lewitt LCT-440 microphone?

A: It is not specifically designed for the LCT-440, but it will fit.

Q: 3. Is this supposed to work with 3.5mm headphones?

A: Yes, each channel has both 3.5mm stereo TRS and 1/4" stereo TRS headphone outputs.

Q: 4. I will be connecting (soldering) this wall mic to a mic cord and was wondering which wires are positive/negative and the same for microphone cable?

A: There are two wires on the back of the mic. The blue wire is positive (+) and the black wire is negative (-). Wiring instructions should be included with the microphone. For further information, you can reach technical support at Telex by phone at 800-898-6723.

Q: 5. What is the recommended ohm headphone to use?

A: The HeadAmp4 is powerful enough to support most consumer and pro headphones which typically range from 32 to 600 ohms.

Q: 6. Could this be used on a ceiling/beam instead of a wall (lagged in properly of course)? Want to hang some pipe from it via a Big Ben Clamp.

A: Yes this plate can be bolted to a ceiling or a beam.

Q: 7. What is the warranty for this?

A: The D'Addario PW-MPTS-06 Custom Series 1/8" Stereo Plug to Dual 1/4" Plugs Audio Cable has a limited lifetime warranty from the manufacturer.

Q: 8. can this mount the Blackmagic Micro Converters?

A: Yes, you can use the BLACKRACK-2 Universal Mini Converter Rackmount to mount the Blackmagic Design Micro Converters.

Q: 9. Will it mount to a Sony FX3?

A: Yes, the Hoodman HCP2 Mirrorless Camera Custom Finder Base Plate for HoodLoupe would work with the SONY FX3. Please note that this is just the mount, and it does not include the Hoodloupe. The best choice would be the 3.0" model but that is discontinued. Hoodman HoodLoupe Outdoor LCD Viewfinder for 3.2" Screens BH #HOH32MB • MFR #H32MB

Q: 10. Can the FX4-SDI perform frame rate conversion? I'm interested in converting a 3840x2160 60Hz signal from a computer to Quad Split 1080p59.94 or 1080p29.97

A: Yes it can.