The Gravity Lighting Stand with Square Steel Base (7.9')from Gravity Lighting Stand with Square Steel Base (7.9')is a general use stand that rises to a maximum height of 7.9', and it features steel construction. The stand will support items weighing up to 44 lb and weighs 39 lb.

Payload: 44 lb / Steel Construction    1 x Section / Minimum Height: 4.6'    Folded Length: 4.6'

Related Questions and Answers

Q: 1. What is the center column diameter?

A: The size of the Godox 240FS Wheeled Light Stand (7.9') BH #GO240FS column is not specified. The stand has a baby receiver that can be used with a variety of adapters to fit different lights, cameras or other equipment.

Q: 2. How well would this fair with a Profoto B10 Plus with an RFI 1X3 Strip box?

A: At max extension this boom is rated for less than 2 lbs. It would not be suitable. The larger Avenger would be able to do it at a partial but not full extension. https://bhpho.to/3bH4yo9

Q: 3. Is the leg 22mm?

A: Yes, the legs are 22mm at the ends.

Q: 4. Is the vertical tube of this model aluminum or steel?

A: Godox does not list the material of the column on the Godox 240FS Wheeled Light Stand (7.9'). Chances are it is steel.

Q: 5. Will this hold an Einstein strobe and beauty dish?

A: Yes. But you will need a counterweight sandbag.

Q: 6. Can this boom pole stand hold a DSLR and lens for a flat-lay filming as well? Thanks!

A: The Manfrotto 208 3/8" Head Mounting Plate with Lock Screws B&H # MA208 can be inserted at the end of the boom in place of the included stud. This plate can then accept a ball head such as the Manfrotto 496RC2 Compact Ball Head with 200PL-14 Quick Release Plate B&H # MA496RC2 to hold your DSLR. https://bhpho.to/2qzA4xA https://bhpho.to/2QuMfg0

Q: 7. Is it possible to use this as a camera stand? If yes, what grip head or other accessory would I need to buy?

A: Yes, you can use Godox 240FS Wheeled Light Stand (7.9') for a camera and you will need to get a ball head of appropriate size, please check the weight of your camera with a lens used and then pick a ball head that has relevant load capacity. As a reference Benro GX35 Two Series Arca-Type Low Profile Aluminum Ball Head https://bhpho.to/3gTyWyn

Q: 8. Can a baby pin be used in place of camera mounting plate?

A: Yes you could use a double pin such as the Impact SRP-113 Long Double Stud 5/8" B&H # IMSRP113 in place of the camera mounting plate.

Q: 9. Does this model include the ratchet lever to lock the boom arm? I ordered this model and it is missing this piece.

A: Yes it does have a lever about 2.5 inches long to tighten the boom arm however it does not ratchet.

Q: 10. Compared to the 420B, apart from lacking a sandbag, is this also a less robust stand? I notice the maximum load is lower for the 420SNB.

A: The Manfrotto 420B, B&H # MA420B and the 420NSB are the same stand, with the latter not including the empty sandbag.