Tv One Magenta Mg-Aoc-883-10 Active Optical Displayport Cable 32.8'

Tv One Magenta Mg-aoc-883-10 Active Optical Displayport Cable 32.8'

Product Code: eq88477
Availability: In Stock

$1,270.50 $1,791.40

Qty

13 reviews Write a review

Description
Reviews (13)

Run your DisplayPort signal over 32.8' without interference with the TV One Magenta MG-AOC-883-10 Active Optical DisplayPort Cable. It supports resolutions up to 8K at 60 Hz along with EDID and HDCP 2.2 to allow the pass-through of copyright-protected content in multiple-display configurations. This directional cable doesn't require an external power source, simplifying your installation. Its LSZH jacket allows for safe installation in applications where smoke emissions and toxic fumes would pose a health risk in the event of a fire.

Supports 8K @ 60 Hz 32 Gb/s Bandwidth Supports 2-Way HDCP & EDID Communication LSZH Jacket

General
Connector 1	1x DisplayPort Male
Connector 2	1x DisplayPort Male
Cable Length	32.8' / 10 m
Interface	DisplayPort 1.4
HDCP Support	Yes, Version 2.2
Additional Feature Support	EDID (Extended Display Identification Data)
Maximum Resolution Support	7680 x 4320 at 60 Hz
Outer Diameter	0.2" / 4.8 mm
Packaging Info
Package Weight	1.69 lb
Box Dimensions (LxWxH)	9.8 x 9.6 x 1.5"

LSZH (low smoke, zero hydrogen) jacket for safe installation in applications where smoke emissions and toxic fumes would pose a health risk in the event of a fire
Supports resolutions from 480i to 8K60 4:4:4 with no compression, latency, or signal loss
No external power required
Supports bi-directional EDID and HDCP 1.4 & 2.2 communication
Four 850nm multi-mode VCSEL O/E converters for transmitter; four GaAs PIN photo diode O/E converters for receiver
Four fiber and eight copper wire design
67.2 lb maximum tensile load
Latches on both connectors
1.89" minimum bend radius
0.5W maximum power consumption each end
Directional design

Related Questions and Answers

Q: 1. What is the latency?

A: There is no published spec regarding latency of the Optical Cables by Corning Thunderbolt 3 USB Type-C Male Optical Cable (49.2'). Any latency would be so negligible that it would very likely not be noticed.

Q: 2. Is this Cable Compatible with Non-Thunderbolt USB C ports(both 10Gbps & 5Gbps) & it's Accessories, or will it act as an Normal USB 2.0?

A: If used with USB-C ports it will have the speed of the port plugged in to.

Q: 3. where can I find just the red rubber grip washer attached to this product please?

A: The Red Rubber Grip Washer is not a part we have in stock, it is a Manufacture's Service Part. Feel free to email us directly at provideo@bhphoto.com and we can help guide you towards the proper place to obtain that part.

Q: 4. Hello, what's the color gamut of this monitor?

A: Regarding the color gamut of the AOC U27U2DP 27" 4K HDR Monitor, it covers 100% sRGB and 98% DCI-P3.

Q: 5. Can I use this cable with a Thunderbolt 3 to Thunderbolt 2 adapter so that I can plug into a late 2013 iMac?

A: No this cable will not work for iMac late 2013 you need Thunderbolt for iMac Mini DisplayPort Thunderbolt to Mini DisplayPort Thunderbolt cable and the item code for this cable is. B&H # APTBC2M

Q: 6. Can you get a picture of this product with the grill off?

A: Currently, Avante does not provide a photo of this speaker without the grill.

Q: 7. What is the shipping weight?

A: The Neumann KH 810 package weight is 69.05 lb

Q: 8. Will this cable carry video as well? Looking to extend video+peripherals between a rack and table location.

A: The Logitech Strong USB 3.2 Gen 2 Type-A Male to USB Type-C Male Cable (32.8') BH #LOSUSB31C33 can carry video signals.

Q: 9. Will this work with Dell U3821DW 37.5" 21:9 Curved IPS Monitor (Silver) to my Macbook M1 Max 16 inch ?

A: The Xcellon Thunderbolt 3 Cable (6.6', 40 Gb/s, Active) BH #XCTB35402 will work with that monitor and computer combination.

Q: 10. Will this cable work with the ASUS ProArt PA329C 32" 16:9 4K HDR IPS Display?

A: Yes, this cable is perfectly compatible.

Andriy	15/09/2024
[1.69 lb] It work 5

Ananda	04/09/2024
[1.69 lb] Works perfectly, no issues. 5

Greg	21/08/2024
[1.69 lb] Bought two of these for driving two 4k TVs at distance. These cables are super thin and worked perfectly. Worlds better than trying to use conventional HDMI cables with amplifiers. Thin and flexible. Just make sure to pay attention to which end goes where. They are clearly marked input/output. Used in a professional environment and would absolutely recommend! 5

Robert	19/08/2024
[1.69 lb] Use it to have a mirror display in my living room it is like having two Mac for one. Also move loud things out of my Sound Studio 5

Christopher	17/08/2024
[1.69 lb] We've had zero issues with these cables, so at this point we can recommend them. 5

Jonathan	17/08/2024
[1.69 lb] lightweight and convenient for shipping 5

David	07/07/2024
[1.69 lb] Purchased for Streaming with some tweaks to the software and upgrade to the internet this cable will be a gamechanger 5

Wesley	03/07/2024
[1.69 lb] I'm using two of these as home runs to my basement from my second floor office. I moved my 2019 MacPro to the basement along with it's raid arrays, etc and UPS. In attempt to remove all the heat and noise from my office. The cables connect to two OWC thunderbolt 3 docks (on per home run) via 2 different thunderbolt ports on 2 different busses and between them runs 4 displays (2 per dock) Works like a champ! I ran them through the walls and in my attic, works awesome! It feels like the machine is still sitting at my feet, no discernible difference! The cables seem pretty tough too! 5

Tom	17/05/2024
[1.69 lb] This HDMI is very thin and flexible.... just what I wanted. It does pass all the camera data from my Black Magic ATEM and turns on and off the recording function od my BMPCC cameras. 5

Edward	15/05/2024
[1.69 lb] I purchased this cable for use with PTZ cameras as an alternative to SDI cable. I shoot mainly at 1080p60 (59.94), for which this optical HDMI cable works perfectly. The image shows the cable on a reel, however it is simply coiled. Taking care to uncoil it without twisting, I put it on an inexpensive orange cable reel sold at nearly any hardware store. It is wound Source End out (the cable is uni-directional) with enough slack at the Display end to reach the switcher. The cable is thin, very flexible, and lays flat 5