Power your Sony FX6 via a V-mount battery with the Anton/Bauer Micro Battery Slide Pro, which steps up the output voltage of your V-mount battery to the 19.5 VDC required to power your camera via its DC input power port. The battery bracket supports standard- and micro-sized batteries, and it attaches directly to the extension unit connector on the top of your camera, which provides an anchor point for compact and secure connection of the plate to the camera without requiring you to mount it on support rods.

The attachment point also acts as a hinge for the plate, allowing you to access the camera's BPU battery slot, allowing you to hot-swap V-mount batteries, and change the V-mount or BPU battery without turning off the camera. Each of the two P-Tap connectors provides unregulated power output from your V-mount battery for powering accessories, and multiple 1/4"-20 mounting holes allow you to attach accessories directly to the plate.

19.5 VDC Output via DC Connector    Mounts Directly on Sony FX6    For Standard- and Micro-Sized Batteries    Allows Access to BPU Battery Compartment    2 x P-Taps for Powering Accessories    1/4"-20 Accessory Mounting Holes

The quick-hinge design retains access to the camera's internal BPU battery compartment, allowing continuous shooting by hot-swapping internal and external batteries

The Battery Slide Pro plate steps up the output of a 14.4V battery to the required 19.5 VDC to power your camera via its DC-in port

The lightweight plate is small in size, for a small footprint when mounted on your camera, but it supports both standard- and micro-sized V-mount batteries

Related Questions and Answers

Q: 1. Will this enable smart batteries to talk with the Komodo body?

A: Yes it will.

Q: 2. Does this pass through battery data to the Komodo?

A: The Anton Bauer Battery Bracket for RED Komodo does not provide battery data to the camera.

Q: 3. What are the sizes of the two screws that secure the slide to the camera?

A: The screws that would be used to secure the Wooden Camera Battery Slide Pro for Sony FX6 (V-Mount) (B&H# WO283000) to the FX6 body appear to be M4 (i.e. 4mm metric) ones. The easiest way to tell that is to see if a standard 1/4" screw (used for mounting just about every type of non enormous camera to a tripod or quick release plate) is about the right size but doesn't thread properly after a couple of turns into the thread. (That should only be done very gently.) If so, that tap is indeed an M4 female thread. If the 1/4" screw is too large to fit in the tap at all then it's an M3 screw.

Q: 4. Will this work with the 26 volt V-Mount batteries like it does with the 14 volt ones...converting the output to 19.5 volts?

A: The Anton/Bauer Micro Battery Slide Pro for Sony FX6 (V-Mount) is designed to only work with 14V V-mount batteries.

Q: 5. Can the slide assembly be lowered on the bracket that attaches to the camera? In other words, can the battery mount be lowered?

A: The battery plate portion of the Anton/Bauer Micro Battery Slide Pro for Sony FX6 (V-Mount) can be adjusted vertically along the camera connection arm using the large tightening knob, which when released will be able to slide along the light of the plate in it's open rail. This is best shown in the final two images where you can see the open rail that the screw would slide along just below the knob itself.

Q: 6. I lost the screws for this piece of equipment. Where can I find replacements?

A: We recommend connecting with Anton Bauer support for the replacement screws. salessupport_USA@vitecgroup.com

Q: 7. Can I couple this with MFR #8375-0239 and use 2 Titon Micros with hot swap capability? If so, will I be able to use every P-tap / USB-A output on that setup?

A: The Anton Bauer Micro Battery Bracket for RED KOMODO (Micro V-Mount) is for one battery. It cannot mount the Anton Bauer Titon Micro Dual V-Mount to Single V-Mount Battery Bracket. You need a V mount on the camcorder to use the Anton Bauer Titon Micro Dual V-Mount to Single.

Q: 8. Will this charge 4 Blueshape Granite Minis (140Wh)?

A: We are not aware of anything that would prevent the Anton Bauer VM4 Quad Micro Battery Charger (V-Mount) from charging 4 x Blueshape Granite Minis.

Q: 9. Can you use the HDMI port or does this block it?

A: The Anton/Bauer Micro Battery Slide Pro for Sony FX6 would not block any of the cameras video output ports.

Q: 10. Hi does this take all kinds of v mount batteries? Or a certain few (i.e. Indie Pro & Anton Bauer)? Thanks.

A: Yes, this will take batteries other than Anton Bauer.