The Auray WSF-2029 Foam Windscreen for Shotgun Micsare designed to reduce unwanted broadband wind noise and vocal pops with minimal high frequency loss.

This WSF-2029 Foam Windscreen has an inside depth of 29cm and is designed for use with long shotgun microphones. The density of the specialty acoustic foam is optimized to help protect the microphone element from air bursts without muffling the sound.

When used on a long shotgun microphone, this windscreen is effective in minimizing wind noise and plosive sounds. It is most effective in calm to light breeze conditions (0-7mph), and can be used indoors for protection against drafts caused by air-conditioners. Users can generally expect a 4dB to 8dB reduction in wind noise, with very slight dampening of high frequencies. For most applications, the very slight high frequency dampening is a worthwhile exchange for the notable wind noise reduction.

The WSF-2029's foam is hypoallergenic and washable and helps prevent moisture and dirt from damaging your microphone. The windscreen is designed to fit microphones from Sennheiser, Neumann, Audio-Technica and others.

The WSF-2029 Foam Windscreen for Shotgun Microphones is an effective solution for basic wind protection.

High-Quality Acoustic Foam    Reduces Wind Noise    Reduces Vocal Plosives    Protects Mic from Moisture and Dirt    29cm (11.4") Inside Depth    Reduces Wind Noise up to 8dB    For Microphones 19-22mm in Diameter

Audio-Technica AT 815ST (BP4027), AT 4071a (BP4071)

Neumann KMR 82

Sennheiser ME 67 + K6 Capsule

Related Questions and Answers

Q: 1. What type of fur windjammer can I fit over this foam?

A: It is a best practice to use the furry without this foam windscreen.

Q: 2. Will this fit over a seinheiser e835?

A: No. The Auray WCF-UB440 is for a large diaphragm condenser mic. For the Sennheiser e835 you can use the Auray WHF-158 Foam Windscreen for 1-5/8" Diameter Microphones (Black), which is B&H # AUWHF158.

Q: 3. Will this foam windscreen properly fit a blue yeti microphone? if not, which will?

A: The Auray WCF-UB440 will fit the Blue Yeti. However, a pop filter is recommended as it will protect you from plosives and sibilance without affecting the frequency response of the mic as a foam windscreen would. The Auray PFSS-55 is a solid recommendation. a href= http://bhpho.to/1rgFOFB target= _blank http://bhpho.to/1rgFOFB/a

Q: 4. will this fit to Polsen Mc- Pod?

A: Yes, the Auray WCF-UB440 foam windscreen will fit on the Polsen MC-POD microphone.

Q: 5. Does it cut down on the High frequencies more than the Sennheiser MKH 416 original windscreen?

A: Any foam will reduce high frequencies very slightly. I doubt you would notice though. It is designed to be as neutral as possible.

Q: 6. Can it fit BLUE YETI ?

A: Yes, the Auray WCF-UB440 foam windscreen can be used with the Blue Yeti.

Q: 7. Will this fit Sony ECM-MS908C?

A: The Sony ECM-MS908C measures 1.1 inches diameter. This Auray WHF-2545 Foam Windscreen would be a good selection, based on the size of that mic.

Q: 8. Does this fit a HMD 280-13 microphone?

A: As you know the Aurray is a diameter. The original part number from Sennheiser is 083411 which I was unable to locate on our site nor was I able to get the dimensions from Sennehiser. I think the Aurray should work. If you are in doubt you can order it right from Sennheiser.

Q: 9. fits with Senal ENG-18RL?

A: Yes it is compatible

Q: 10. Will this fit over Samson's C01U Pro USB Studio Condenser mic?

A: This windscreen will fit on the Samson C01U Pro USB Studio Microphone.