Get a fantastic and huge sound out of a relatively small 1x12 cabinet thanks to the Hughes & Kettner TS 112 Pro 100W Cabinetfrom Hughes & Kettner. This 16-ohm 100W cab loaded with a Celestion G12H-75 Creamback speaker is perfect for getting a punchy yet balanced sound at high decibel levels.

The cab was designed to pair with the Black Spirit 200 combo amp as an extension speaker, so you could get the full 200W owed to you by the amp itself. However, the cab offers a full and present sound paired with any compatible amplifier, thanks to the front-ported construction of the cab.

100W of Balanced, Punchy Tone    1x12" Construction    16 Ohms    Pairs with Black Spirit 200 Amp    Works Well with Any Compatible Amp    Celestion Creamback Speaker    Ported Construction for Optimal Low End

Related Questions and Answers

Q: 1. How do you insert the bulb and attach the barn door?

A: The top of the light opened up and the bulb just twest in. The barn doors just slide in to the tracks after you turn the top LACH

Q: 2. How many audio channels over USB are supported in class compliant mode? Can one route eg 32 channels from USB to Madi and then another 32 from adat to madi?

A: USB 2.0 (44.1 to 48 kHz): 64 in/out USB 2.0 (88.2 to 96 kHz): 32 in/out USB 2.0 (176.4 to 192 kHz): 24 in/out

Q: 3. Will a Banana to 1/4" Male Phone speaker cable insert directly into the 5 way binding post output without adjusting?

A: Yes, the binding post on the ART SLA-1 100W 2-Channel Amplifier is going to accept the banana plug without any need for adjustment.

Q: 4. What is the difference between the CDM-100 and CDM-100W?

A: a LEMO 7-pin angled connector

Q: 5. is it white light or yellow?

A: This is a 3200k warm color temp.

Q: 6. What is length: end-of-snapclip to end-of-snaoclip?

A: The strap's length is 20.75 (52.71 cm)

Q: 7. Where is it made?

A: This product is manufactured in Taiwan.

Q: 8. Where do you plug in to Anker 522?

A: The Anker 625 Solar Panel plugs into the DC input port on the Anker 522 Portable Power Station.

Q: 9. Can I use this Hosa Technology Pro REAN XLR Female to 1/4 TS Hi-Z Microphone Cable to the out put of the Behringer MIC100 preamp and connect it to my guitar amp (with 1/4 TS unbalanced input connector)?

A: This cable will allow you to connect the output of a mic preamp to your guitar amp. This application however is not generally recommended mostly due to the guitar amps being midrange heavy which causes feedback issues with microphones, also the preamp outputs a line level signal which is hotter than the instrument level signal most guitar amps are designed for.

Q: 10. Will this work with the D-Lite 400W/s RX 4 Flash Head? It requires 100W / 90 V / E 27 bulbs.

A: This will work with any of the D lite 4, 2 or ONE monolights.