[Universal] I will admit that the price point on this product is high very high but ease-of-use and ability to distribute the weight of a fully built C300 Mark ii Tilta rig w/28 to 300, IDX battery, Teradek bolt 1000, Lectrosonics SR unit is amazing.
Can’t really describe how it takes the fatigue off of your shooting shoulder arm and wrist and even at the end of that lens provides an extremely sturdy platform ... you just have to strap it on and try it yourself .
Also very easy to move the rig to your waist or pop it off completely and get down on a cinesaddle on the ground
makes it so much better than an easy rig

[Waist Support] I'll never use another shoulder pad with my FS7. Most other setups don't let you slide the pad into any spot you want which is crucial for achieving the right balance. Most other pads are fixed below the center of the body, forcing you into a front-heavy build unless you have a tiny, super lightweight lens.

8Sinn's sliding baseplate lets me center the shoulder pad underneath the sensor & lens mount for much better balance. I love the magnetized pad too and how you can move that around a little after you place the sliding baseplate. Contrary to what others have said I actually like the Allen key front rod setup because I tend to put accessories that will shift on top-mounted rods with quick releases and accessories that are more fixed (like lens supports) on the bottom rods.

[Waist Support] Maybe the perfect shoulder pad. To have a manfrotto 501 style plate offers the option, to switch between tripod and shoulder configuration very quickly - withhout an VCT tripodplate. This plate is very well made and feels good on the shoulder, even with a heavy set up.

[Waist Support] The stands are extremely heavy duty, and also a little heavy to boot. Quality is better than I expected and we should get many years of good service out of these. The only drawback is the aluminum bracket that slides up and down with a locking pin has some very sharp edges and burrs. It would be a good idea to take a little Dremel with a grinding wheel and round off a lot of these edges to keep from slicing your hand open. That is the only minor drawback that I can find with these. Get them you will not be disappointed.

[20 x 7.9 x 7.6"] This is the among the best tool besides my camera that I use. I’ve gone from about 5-10 minutes before my hand starts to numb to about an hour without any serious discomfort. The harness balances the weight across both shoulders and it seriously makes a significant difference in how long I can go handheld. It also makes my shots more...steady.


It's expensive, but if you lug a full-size ENG camera around, (Mine weighs about 22lbs fully loaded,) and you consider how much you pay for your tripod and other support gear, it's really worth every cent.

[Waist Support] These stands are great, easy to use under load!

[5.29 lb] It's well build and well thought through piece of gear. It's one of the smallest and lightest VCT shoulder plates I've tried. The only drawback for me is the design of front rods adapter. You have to take the plate off the VCT adapter and then use allen wrench to tight them in. I guess it's the sacrifice for being so small (locking levers don't stick out, which is the benefit compare to other brands).

[5.29 lb] Adding this plate to my octabox really makes a difference. I use it for headshots and photobooths and this extra addition was exactly what I needed to smoothen out the strobe and utilize the full softness of the light that the Rapid box can offer!

[20 x 7.9 x 7.6"] 8Sinn makes high quality and attractive gear. It's nice to have an alternative to the mega-expensive brands that's still a step up from the cheap stuff. 8Sinn is a very happy medium.

[Universal] I just think that you are nuts not to buy this accessory for the Rapid Box Octa XL and XXL. The light deflected off the plate spreads so nicely out of the box.