Film Devices Hirose To Dc 2.1X5.5Mm Power Cable 15.5"

Film Devices Hirose To Dc 2.1x5.5mm Power Cable 15.5"

Product Code: eq96608
Availability: In Stock

$90.00 $132.30

Qty

20 reviews Write a review

Description
Reviews (20)

This 15.5" Film Devices Hirose to DC 2.1x5.5mm Power Cable 15.5"is an adapter cable used to provide DC power to various Lectrosonics wireless devices. It lets you plug the output of a sound-bag Distro power-distribution system equipped with a Hirose connector into the DC power-input connector of the device.

The cable is compatible with Lectrosonics UCR411, UCR411A, UCR401, UCR400A, UCR211, and LR (with adapter) devices. It is terminated with a straight Hirose connector at one end and a 2.1 x 5.5mm straight DC connector at the other.

Power Cable for Lectrosonics Wireless Use with Sound-Bag Distros Straight Hirose Connector 2.1 x 5.5mm Straight Connector

Parameters
Compatibility	Lectrosonics UCR411, UCR411A, UCR401, UCR400A, UCR211, and LR (with Adapter)
Connector 1	Hirose, Straight
Connector 2	DC 2.1 x 5.5 mm, Straight
Length	15.5" / 40 cm

Related Questions and Answers

Q: 1. what is the length of this cable?

A: The cable is approximately 10".

Q: 2. Does this hirose DC input sled work with the Sound Devices MixPre 10T as far as room for cable is concerned (i.e. without bending it too much)?

A: Unlike the MixPre 3 and 6, the MixPre 10T sports a Hirose 4-Pin DC input connector, so this accessory is not needed for the 10T.

Q: 3. Does this provide power regulation when used with a V-Mount battery? I don't see a recommended voltage range in my MixPre-6 manual.

A: This will regulate power of an external battery to properly run the mixpre6.

Q: 4. Would this work with a LP-E6 dummy battery with the Blackmagic Pocket 4K?

A: While that may be possible, we are not aware of a specific dummy battery that will work with this cable at this time. So that we may best assist you finding the proper product for your needs feel free to email us directly at askbh@bhphotovideo.com.

Q: 5. Would the Ronin S be able to power the Shogun Inferno with this cable?

A: No because the shogun inferno has a 2.1 mm DC barrel

Q: 6. What Hirose to Dtap connector is recommended for this, to connect this directly to a V Mount D Tap?

A: We offer BH #RECAPTAPHIR and if you require right-angle connectors we also offer BH #CAC2537

Q: 7. Does this work for the Ninja Inferno as well?

A: This is not compatible with the Inferno. It would just be compatible with the Blackmagic Video Assist and the Shogun Monitor.

Q: 8. Does this work with Sound Devices XL-WPH3 45W DC Power Supply? And with Remote Audio Anton Bauer PowerTap to 4-Pin Hirose Male DC Power Cable (14 ) to power MixPre-6 off Anton Bauers? Thx

A: The Hirose DC Input has a voltage range from 10-20v. So do not power from mains IEC it will fry the unit.

Q: 9. Will this work with the Feelworld LUT6s?

A: No, this cable will not work. However, this cable should work: https://www.bhphotovideo.com/c/product/1411731-REG/watson_ps_12v2a_21_12v_2a_power_supply.html?sts=pi&pim=Y

Q: 10. Would this be able to power a SmallHD monitor (or similar 5" inch monitor?)

A: We are not aware of this cable being able to power a SmallHD Monitor with the Ronin-S.

Todd	28/09/2024
[15.5" / 40 cm] The dtap fits very snugly in the receptor. I have a nice Canon lens and it powers everything with no problem. I use it to power the lens I use on my Sony EX3. 5

Tristan	19/09/2024
[15.5" / 40 cm] I use this to power my Fujinon ENG lens (HA17x7.8) from a v-lock battery distributor (Tilta) attached to my Blackmagic pocket camera. It works great and is great value for money as it's a lot cheaper than the genuine Fujinon cable. 5

Mark	08/09/2024
[15.5" / 40 cm] I use this with a MixPre-3 and a hirose-to-d-tap cable. Works as expected. Its awesome to be able to power the MixPre off camera battery. Would buy again. Only suggestion I have is that if you do use this to power your MixPre, and if you feed a signal back into your camera (i.e. not just record to the MixPre, but also send a scratch track signal from the MixPre to the camera), then you will want to get a ground loop isolator to put in your signal chain. Otherwise the in-camera scratch track will have interference noise. (The internal MixPre recording remains pristine.) 5

Laurent	02/09/2024
[15.5" / 40 cm] Very sturdy and well built. Very pratical to switch battery and hold battery plugged safely. 5

Gustave	29/08/2024
[15.5" / 40 cm] I have been using BB for years. It is reliable and hasn’t failed me yet. I think it is a great device for ENG Audio Tec’s. 5

Adam	04/07/2024
[15.5" / 40 cm] I got this hopefully remove the ground loop hum that would occur when using a battery eliminator for my Sennheiser G4s. If they were connected to my main battery distro, the connected Zoom F8n would cause unacceptable ground loop, and thus prevent me from using the battery eliminators. I bought this and experimented a bit and found that if I put this power isolator between the G4 and the battery distro box, the hum was effectively gone (only noticeable if recorder gain was set way higher than I would ever use). I plan on buying a second to use with the second G4 so that I can more effectively get the most of of my battery distro system. 5

Bruce	01/07/2024
[15.5" / 40 cm] I'm using this along with my MTF B4 converter with my Canon J9X5.2 lens mated to my Sony NEX FS700. It works like a charm. Very high quality in parts and workmanship. 5

Jesse	26/06/2024
[15.5" / 40 cm] This cable simply works. I had a BDS that required this cable and B&H was there with the best price and great shipping time frame ! 5

Lars	24/06/2024
[15.5" / 40 cm] It is small and compact. I picked up a cable that is D-Tap to HIrose. I reached out to the Sound Devices about the wiring of this to make sure I could check if cables would work. Pins 1 and 2 are wired together and are positive, pins 3 and 4 are wired together and are the negative. This way you can check with cable manufactures to make sure it is wired correctly for your unit. 5

Tristan	19/06/2024
[15.5" / 40 cm] Works great!! I use it to charge my Timecode and other small USB devices in the sound bag (and sometime my phone in a jam) . 5