The ETC Unison Foundry 600W DMX Dimmer 120Vfrom ETC Unison Foundry 600W DMX Dimmer 120Vprovides DMX-controlled line-dimming of various load types, to include Electronic Low Voltage, incandescent, and fluorescent loads. The dimmer supports loads between 1 and 600W and features an automatic detection of the required dimming mode with a manual override.

120 VAC, 600W Dimmer    Single Channel    DMX Controlled, RDM Configurable    Auto and Manual Dimming Modes

Related Questions and Answers

Q: 1. Can this be used outdoors in a covered patio?

A: you can use this outdoors provided it is not exposed to the elements

Q: 2. Can i use this dimmer with filament tungsten bulbs?

A: Yes. Unit will work just fine for you filament tungsten bulbs.

Q: 3. Will this work with LED bulbs in a string as long as it doesn't exceed the total watts of the bulbs?

A: I've found that it is more about the lamp than the dimmer. Many consumer grade LED bulbs claim to be dimmable on the package - but in use they flicker below 20% fading.

Q: 4. Will this 600w 120v bulb work with the Arri 650w fresnel light? Or just the Arri 600w open face light?

A: The Impact DYS Lamp (600W, 120V) will NOT work with with the ARRI 650W Plus Tungsten Fresnel (120-240 VAC) the correct lamp is a Osram FRK (650W/120V) Lamp

Q: 5. Will this go from full brightness to OFF, or just a really low dim?

A: It goes all the way from full brightness to bulb off but the unit is still on. There is no light coming from the bulb but the unit itself is not off.

Q: 6. What is the total watts for each channel? Blew a fuse after 10 minutes with two 650 watt arris plugged into a single channel.

A: The max wattage per channel is 600 watts. This is not beefy enough to run your Arris.

Q: 7. Will this work with quasar cross fade tubes? And also could you control the lights through an extension cord?

A: This should be a suitable option for dimming the lights.

Q: 8. Will it work with Arri 650w?

A: Yes, 650w is within the tolerance of this dimmer. I have used it with my 650 many times.

Q: 9. Does it can work with multiple voltage?

A: Yes, CHAUVET DJ DMX-4LED 4-Channel Dimmer Pack is multi-voltage, 100 to 240 VAC, 50 / 60 Hz at 5 to 15 A

Q: 10. Can this dim a 56 foot long LED strip light? I think the total strip is 245 watts - much less than this is rated - but is there a different between LED and Quartz Halogen or Incandescent Lamps? (This dimmer says for Halogen/Incandescent)

A: I'm not an expert but your LED strip light works with a transformer which convert the 110 volt to a different voltage (probably 12 volts) to give power to the LED light. So I'd check your light transformer to be sure that it was made to be dimmable. If I was you I would check to buy a LED strip light transformer with a built-in transformer but again I'm not an expert.