Belden Cat6A Cable

[24 AWG] Belden is the way to go. Reliable and sturdy cable. Pretty flexible too, all things considered.

[0.52 lb] Comes bundled with a CAT6A cable, low profile, plug n play, affordable price.

Comes bundled with a CAT6A cable, low profile, plug n play, affordable price.

[Analog, Passive] We used 2 of these boxes, with Whirlwind sheilded Cat6a cable and couplings. Ran 300 feet between the 2. Had no issues. Clean sound. We also ran 1 channel of 3-pin DMX with audio running on the other 3 channels. No problems! We love these.

We used 2 of these boxes, with Whirlwind sheilded Cat6a cable and couplings. Ran 300 feet between the 2. Had no issues. Clean sound. We also ran 1 channel of 3-pin DMX with audio running on the other 3 channels. No problems! We love these.

[3.0" (76.2 mm)] Belden 1694A is the best cable for top residential CATV performance. Very noticeable difference between Belden and their competitors wire. You cant come close to beating B&H's pricing and quick service. I will be ordering all my cable from B&H!

[Indoor] I used this tool in combination with the following Belden components and my video system install went very smooth without any issues. This compression tool grips the connector evenly and compresses very smooth. Belden Cable Strip Tool for RG59, RG6 and RGB Mini-Coaxial Cable Belden CPLCRBC-BR Double Bubble Compression Tool Belden 12G-SDI 75-Ohm UHD 4K Mini Coax Video Cable (1000', Orange) Belden 12 GHz Mini RG59 BNC Compression Connector for 4855R Cables (50-Pack)

[0.145 lb] This crimpers works for many cables. I purchased it for Belden 1855A cable and 1855ABHD3 BNC connectors. Works great! Crimps everything on nice and tight. Leaves a nice flared edge, you can crimp all the way along the feral if you wish. (I leave it so my heat shrink has something to grip onto) If you have different branded cables, you can also change the Dies. Will serve me well for many years! Also my favourite colours... orange and black!

[5 to 95%] I specifically purchased this cable stripper for my Belden 1855A cable, it does come with a default setup on the blades. But mine needed a little fine tuning. (About 15 mins of testing) Its easy to do once you figure out how it works (read the manual!) Make sure you twist it around the cable at least 20 times. Its not hard and takes a few seconds. On the final step before removing the cable from the cutter, you need to press down on the yellow handle (you will understand once you get the product), only put light to medium pressure on it. As it cuts the outer layer along the cable for ease of removal (again, you will understand once you try it). If you press to hard, it will also cut the inner shielding layer! (practise this step during your blade adjustment process) Im using the Belden RG6 BNC connectors (1855ABHD3) and its cuts it perfectly for these as well. Very happy and well priced (compared to Australian prices). Once its setup, takes about 5 mins a cable to make now! (Cutting cable length, stripping ends, crimping connectors and heatshrink) Could probably do this faster, but im watching youtube at the same time...

[10' / 3 m] We were desperately trying to find Belden 4694R connectors and no one had them. We were told by another vendor that these connectors would work and they did. Since we're using the 4694 cable for HD only, we'll be okay. If we upgrade to 4K, they'll probably work too because our cable lengths aren't over 150 feet. Quality connectors and extremely easy to put on cable with the Belden tools.