Bluetooth And Wired Headsets

[Black] Best bluetooth headset that I have had so far. I've gone through two sony headsets in the past few months and these are by far the best I've come across.

[11 x 9 x 7"] I replaced some older EarTec's with wired headsets - no wires is much nicer. They eliminate static, but require a minimum level of speech volume to pick up - so you can't whisper too quietly if the event requires it. Otherwise very nice and lightweight, comfortable to wear.

[1.152 Mb/s] We started using the Eartec last week and found them to be very nice. We put our wired headsets away after 30 years of use. they still work and have a bit of static. The headsets are a little tight to wear, but I feel after a little usage they will be Ok. We are currently only using the first 3 headsets on Channel one and have not needed to use Channel 2 until we have a large performance in Church. One cameraman said he heard it beep a couple of times but had no other issues. Not sure if the battery was weakening or if it lost communication, will check it our next week. So far so good.

[USB-C] This product has surpassed my companies expectations we have over two hundred Bluetooth headsets and roughly 30 of these and they are best in our fleet.

[USB-C] Love it! I like that it’s Bluetooth and and has a aux cable, just in case I want it to be wired. The sound is great.

[Omnidirectional] I have been using headsets for business telephony for more than 30 years and finally found a set that I am not disappointed in. I gave up on bluetooth headsets for too many reasons to list here. Sound quality is crystal clear and the earpads are so comfortable I almost forget I am wearing them. Controls located 'mid-cord' well designed and easy to use. Overall feels like a headset that should cost much more.

[20 Hz to 20 kHz] Crystal clear quality! I've had so many issues with other headsets (wireless/Bluetooth) that I wanted to give this a try. The USB cord is long so it doesn't keep me "tied" to the area. The volume is great which makes the audio quality even better!

[Yes] I have a ton of Vello shutter remotes/intervalometers; wired, wireless, bluetooth.... I like the wired ones because, essentially, they never fail unless the batteries are dead. The other ones I have, something always seems to go wrong when I need the thing. The corded ones haven't failed me yet!

[0.15 lb] I already have a pair of traditional wired ATH-M50X but decided to treat myself to the bluetooth version. They are basically the same headphone I already have, but without a cord. They do come with a cord, but it is quite short and isn't coiled. They come with a USB charging cord that is VERY short at about 14 inches. I find this a little too short, but it gets the job done. The instructions were a little TOO simple and consisted of just images and very little text. It was enough to get me started, but there was no information for any sort of troubleshooting. As this is my first bluetooth device, a little more information would have been helpful. The problem I had was once I connected with the transmitter that connects to my 'legacy' equipment, that was the sole device the headphone wanted to connect to. It took a little fiddling around to figure out how to get the headphone to connect to my laptop and cell phone. It would have been nice to have troubleshooting instructions. All that being said, the headphones sound as great as the wired version. I haven't had any problems with interference or a dropped signal. My house isn't very big so I can't really get out of range without going outside which I haven't tried yet to see how far the signal reaches. Great Headphones!!

[6.25 lb] Though I could use a wired MIDI interface, having a bluetooth version makes the setup time minimal to interact with my computer or iPad. Not having to do any work to start sequencing makes this tool a joy.