Catv High Pass Filter

[1] A friend of mine recommended this to me and I'm greatful. I use this high pass filter to cut low frequencies going to my in-ear monitor and also to cut low hz on side wash powered monitors. I get plenty of bass from my main subs so the Shure A15HP is a good fit for my situation.

A friend of mine recommended this to me and I'm greatful. I use this high pass filter to cut low frequencies going to my in-ear monitor and also to cut low hz on side wash powered monitors. I get plenty of bass from my main subs so the Shure A15HP is a good fit for my situation.

[0.735 lb] I really like the hard case it came in & The high pass filter feature.BE SURE TO BUY 3 PIN XLR MALE TO FEMALE CORD, AS THIS MIC DOESNT SUPPLY ONE.

[Aluminum] With this filter, I am able to slow down water even in bright sunlight. No more waiting for a cloud to pass over.

[Strain Relief] High quality pass-through all in one crimp tool that has ample crimping force. Recommended.

High quality pass-through all in one crimp tool that has ample crimping force. Recommended.

[31 x 8.9 x 5.6"] Dont pass it up

[0.19 lb] i got this filter pro enhancer because the spectral band pass reduces the white light glow on my spectrograph..so if you have a visible over bright image this will cut the light by about 1/2. i can use this infront of the spectrograph input and take longer exposures of the IR UV and NIR

[10 to 85%] This is by far the best non-Ethernet home networking solution on the market delivering near 1G Ethernet speeds.� There were some teething issues for me that I had to resolve, but since then my three adapters have been rock solid.� So much so I just bought 2 more. A few tech notes from the issues I had to resolve.� High frequency bandwidth is everything for these adapters.� Make sure you have RG6 wires, this should not be an issue if using cable wiring preinstalled in the last 30-40 years or more recently by the cable company.� In my case the in wall wiring was OK with RG6 cable.� However a previous owner had used cheap R59 jumpers (with cheap twist on terminations) between a rat's nest of cheap Radio Shack splitters that couldn't pass more than 1 GHz.� I bought a higher quality 6-way splitter rated up to 2 GHz.� I also found that having a filter designed to contain the MOCA signals within the house was an absolute necessity.� This filter is installed at the input to the splitter for me.� I think the filter either addressed a high frequency impedance issue or controlled signal reflections that were causing issues.�� As an aside to anyone who cares, these adapters do pass VLANs and probably any other Ethernet L2 items like jumbo frames and the like.� I believe all MOCA adapters do is to encapsulate Ethernet frames and seamlessly pass it over the MOCA network.

[77 mm] I was a little concerned about how much IR light would pass through the in camera filter on my unconverted D610. I have obtained some very nice captures with the Hoya R72 at F8 ISO 100 and exposure times of 8 to 20 secs. There is enough visible light transmission for some color effects using LR and PS. This was a good purchase for my first foray into IR photography.