Cbs Digital Antenna Channel Chicago

[0.04 lb] I will be covering the Chicago Auto Show with the Lanparte Gimbal and GoPro set up for my YouTube channel.

[20 dB (Typical)] Have non-amplified antenna in the attic - and that line is split 3 ways. The 2 smaller TVs weren't dropping 2 channels, but the larger TV with Samsung HDTV tuner, loses 2 channels every minute or so with weak signal. After installing the Winegard - no more weak signal on the one channel. The other channel is very watchable now with less drops. Very satisfied.

[0.755 lb] I own 2 of these, one holds 4 Shure ULXP receivers with the antenna/ power disto and the other holds a Behringer S32 Digital Snake I/O Box perfectly (should be listed on the S32 page because it fits so well...)

[12 VDC at 3 A] I purchased this to replace an analog IEM antenna combiner that I was using on a Digital IEM platform that was having issues with dropouts and interference. The original (high-end professional) product had been recommended by another supplier, and I was skeptical that it would make any difference to replace as it was amplifying and combining the same signal. This combiner (made specifically with tuning to support Digital IEM's) instantly fixed all of the issues I had been chasing for months. The IEM's are now solid from hundreds of yards away, and no dropouts. This thing has saved my productions.

[Yes] i love this television. setup was a breeze. connected to wifii, with digital antenna, and voila, hundreds of channels.

I purchased this to replace an analog IEM antenna combiner that I was using on a Digital IEM platform that was having issues with dropouts and interference. The original (high-end professional) product had been recommended by another supplier, and I was skeptical that it would make any difference to replace as it was amplifying and combining the same signal. This combiner (made specifically with tuning to support Digital IEM's) instantly fixed all of the issues I had been chasing for months. The IEM's are now solid from hundreds of yards away, and no dropouts. This thing has saved my productions.

I own 2 of these, one holds 4 Shure ULXP receivers with the antenna/ power disto and the other holds a Behringer S32 Digital Snake I/O Box perfectly (should be listed on the S32 page because it fits so well...)

[Standard] I use this cable to connect a Midas 32 channel digital stage box with a mixer, in a variety of venues, for recording gigs that generally last one evening. That makes for a lot of setup and tear-down. ProCat-5 cable is expensive, and takes a week or so for delivery, but it's worth every bit. This cable has a rubber jacket that is very tough. Best of all, it lays dead flat, making it easy to keep out of the way or tape down in traffic areas. I keep 100' to 300' on reels, but small stuff (25', 50') is easier to carry in taped coils. I keep a few Neutrik Ethercon unions on hand to combine lengths. I have some hard jacket cable, which is supposed to have better transmission. However I have no data issues with Procat-5 cable at all.

[24-Bit] Use to mix drum mikes down to one output channel for home digital recording. Recently purchased, so limited use. Simple to use, fantastic performance. No cons to date

[1 GB DDR4] We have used the Cisco SG series switches for many years and were disappointed when the line was discontinued but the new CBS line is just as good. Some minor variations in how the software is laid out but otherwise, they are just as easy to use as the SG line.