Cooling Water Cpu

[300 to 2450 rpm] As simple as it comes for water cooling a cpu. Always been a fan of custom loops but decided to go with this instead this time and not disappointed at all!

[4-Pin] Great cooling for the CPU, everything about this product is to love for.

[Yes] I got this CPU for my first computer build and so far it works as expected. It's powerful but it does run hot, so make sure to have enough cooling for it.

[RGB] It's quiet, it looks good, and it keeps my CPU cool. I didn't have to put water in it. It already came with it.

[Dual-Slot] I am not a gamer, but I do a fair amount of video editing in DaVinci Resolve Studio. Before I purchased the 3060, I had a PNY 1660 ti installed in a Dell XPS 8940 running an Intel Core i7 and a 350W PSU. Using the original setup, I rendered a 1 minute 50 second timeline in 1 minute. I noticed the cpu cores would get warm (80-85C) and the cooling fan would speed up noticeably. Once I installed a 500W PSU and the 3060, rendering for the same timeline reduced to 37 seconds, the cpu temps did not exceed 65C and the cooling fan did not speed up. I also noticed in editing mode that video playback was smoother. A big thank-you to B&H's Mendel for tech support in helping me in my purchase decision.

[Thumbscrews] Ever since top vents started coming into vogue, I've longed for a case like this to make an appearance, and it's everything I wanted. The key differentiator of this case compared to most other, modern cases is that it has no vents on the top. For air cooling, this is ideal because you want air to go through the CPU cooler and out the back, not go out the top and skip the cooler entirely or come in from the top and screw up the flow direction. There is a slope in front of the top-mounted PSU that forces the incoming air from the empty space at the top of the front fans down into the CPU cooler. Then the GPU area is fed by additional fans on the bottom to ensure there's plenty of fresh air. This amount of airflow allows you to run the fans at pretty low speeds, being almost silent at 60% in the front and 40% on the bottom, while not significantly reducing the cooling potential. There are mesh filters in front of both sets of fans, keeping the interior a lot cleaner than it would be without them. The panels pop off nicely with some sort of magnetic or tension mounting. Overall, the design of the toolless access and working inside this case feels like an improvement over the Meshify C case I had before. Of course, there is one compromise. If you want non-nvme drives, it only has room for a couple on the rear of the motherboard panel, and there's not much airflow in that area, so I'd hesitate to use a spinning platter hard drive. At this point, I only use nvme drives and a separate NAS for storing media, so that's no problem for me.

[Aluminum] Works great on cpu cooling. I have the ProArt case to match and a ASUS ProArt Nvidia GeForce Rtx 4070TI Super gpu to match. My cpu that this thing cools is a AMD ryzen 7800x3d

[AM4] The Ryzen 7 CPU is a fantastic core processor that does a satisfactory job computing whatever tasks you assign to it. The included cooling fan does it's job well and includes thermal paste for that little extra cooling efficiency.

[1x PCIe 4.0 x16] This case fits the build - any... No issues and very artistic indeed. It's not an airflow case so consider water cooling for sure. However, even with fans it works.

[ATX] I like it better then my Corsair 5000D if that tells you anything. Best mid-tower for external water cooling. I run a giant 16 fan radiator externally on all my computers and I love small cases that can still fit an ATX motherboard.