Extension Cable For Headphones With Mic

[5 x 4.55 x 0.8"] Purchased this 12-foot TS Mic Extension Cable for our Williams Sound Pocketalker.This allowed us to easily remove the mic from the Pocketalker and extend the mic to the TV. B&H was great as always and theirprice was right.

[5 to 95%] I got it as an extension for my headphones and it works great.

[Black] I bought it to use for a unbalanced stereo mic extension. I tested it using it with headphones before putting it into service. There were no intermittent connections. Using it with the mic, there was no perceptable induced hum, unlike other cables I have.

[Vest System] I needed a headphone holder to keep my headphones and headphone extension cable handy and organized by my stereo sound system. This product is of sturdy aluminum constriction and should work well for its purpose. Installation was quick and easy as well.

[1x 3-Pin Female] I had a hard time finding a extension cable long enough for my headphones. I don’t like wireless headphones for a few reasons so these were exactly what I needed. The Good reviews on the quality of this company’s products was another reason I bought them.

[1.02 lb] The meet up mic extension cable worked great. The Strong USB cable did not work at all !

[0.075 lb] I use it as an extension for my headphones to reach my phone. It works well

[24" / 60 cm] Not a lot to say - it's an extension cable.

[Articulated] I use this studio arm to make recording of my voice - for my YouTube videos easier. I did have to pull the cable out a little further near the end - where the mic plugs in. In order to allow the best configuration of the mic (with an isolation mount attached) without crimping the cable end - near the connector. One little note is that if you use the extension arm, make sure to have the retaining screw at the base of the mount out as much as possible - also make sure that the arm is all the way in. It might be a little difficult to know when it's all the way in, just push it in until you know for certain that it is fully inserted into the mount. (When I first set up the studio arm - while using the extension arm. I thought it was all the way in, and it wasn't - which could have caused the studio arm to fall, which would have messed up my computer)

[10' / 3 m] I needed a 10 foot extension cable to mount my shotgun mic on a tripod away from my camera and this cable does exactly that.