Macbook Old Charger Tip Converter To New One

[1.68 lb] Old cartridge, 10% toner, started making noises. New one is silent.

[12 VDC] Old battery quit working, to the point of not even allowing the UPS to turn on anymore. New battery working like a champ, great price for B&H, fast shipping, packed well. All I can ask for!

[Percussion] New drum unit for Brother laser printer. Old drum unit met it's life expectancy and was replaced with this exact same model. Meet the new drum, same as the old drum. Shipped fast, east to order, no problems.

[Yes] I just finished installing this product. It works great! I had a bit of an issue since I had a previous (older) ORBI System installed. I made a couple of mistakes during the installation. However, after a bit of research, I have now installed both ORBI systems (the OLD and the NEW one!) How? - I will try to explain it as easy as possible: 1. Unplug ALL YOUR DEVICES from your OLD Orbi system (in my case was the AC300) (Router and satellite(s)) and of course, disconnect them (Router and Satelite(s) from grid power. 2. Follow TO THE DOT the instruction on your NEW Orbi System (AX6000) (e.g. use the App, etc) when you reach to the point of renaming your SSID/password, use the SAME credentials as your previous system. 3. Verify that your devices (mobile phones, computers, etc) are connected to the internet (via Ethernet, WiFi). 4. Finally, reconnect your OLD Orbi system in the same way as it was installed before.(Connect router to your Modem, power it on, then the satellite(s), etc) At this point you should have BOTH Orbis working for you. There is one little caveat though: In your ORBI APP you will only see the NEW Orbi. The way you can check this is: if you have a device (a mobile phone purchased after 2020) you should see the little "6" next to your WiFi connection when you are connected to the NEW ORBI. If you get closer to the OLD Orbi satellite, the little "6" will go away. This means you are connected to the OLD Orbi. Good luck.

[1.975 lb] Old ZUMO began to get darker and darker. Fine at night. New ZUMO fit Harley mount. Still needed to take front off fairing to run the wires. Now looks like it did when it was new. 2010 HD Ultra Classic. So far works great for short trips now. Sturgis next.

[256 GB] Works for New MacBook Pros. Plug and play. Easy peasy.

[1] Great design for such a simple but important device. Old Nikon charger cracked so we had to replace. This is a modern compact design which fits Nikon batteries perfectly and includes a USB port. It is a great travel companion for North America and abroad--twin pin adapter included.

[0.05 lb] Allows me to use my old MagSafe Charger with my 2014 MacBook Pro.

[Ethernet] I was concerned that I wouldn't be able to configure this with my New M1 MacBook Air. Audiante said they would have support towards the end of 2021, not sure why the long delay as complicated apps like Adobe already have started their transition. This adaptor is great for transmitting audio with zero perceptible latency over the network. You'll need a POE+ switch or power source, and your laptop must also be connected via ethernet since Dante doesn't work over WiFi.

[2.255 lb] Bought the AVT-3155A Scan Converter by AV Toolbox to our new MacBook Pro with our existing teleprompter that requires NTSC component video input. Worked great right out of the box.