Micro Atx Mid Tower

[128 GB] Fit well in a Fractal Focus G mid tower.

[2.5"] Fits well in Mid Size tower. Easy install

[36 MB] Very well designed for ATX/Micro ATX motherboards. Great value for money.

[2x 2.5"
] This thing was incredibly easy to build in and it's running just as well as my big ATX full-size tower was but taking up a lot less desk space and it's nice and quiet even under full load. Would highly highly recommend!

[16.935 lb] Biggest mid tower i have seen fit everything great inside looks awesome with all the rgb piece inside.

[Tower - 1U] I just move all my components (except motherboard and power supply) from an mid-Atx case to the NR200, and I was able to keep the same temps I had in the bigger case. Rtx3090 (from an Alienware PC) Ryzen 9 5900x, 64Gb Ram and 2Tb m.2 ssd drive, 850w SFL Power Supply.

[78.28 lb] I didn't want a mid ATX or a super small micro, this thing just right. Plenty of room and cable management accessories. Plenty of fan and radiator options. My only gripe would be that the front IO (USB and power button) are attached to the detachable frame not the actual frame of the case. This makes it a little finicky when removing the front panel. Though you don't have to remove the front panel to remove the front dust filter: just pull out the bottom filter, then there's a wide latch you can feel under the front panel, that pops off the mesh front and filter. I do love this case, wasn't sure if like the dark glass but it's perfect with rgb fans, just bright enough to see everything without distracting while gaming.

[Bottom] So I haven’t built a pc in ten years and used a MSI mid atx mobo in this case with no issues whatsoever. I love the plexiglass on the side it almost looks like tempered glass and it’s tinted just enough. Instructions and supplies were perfect and clear. I would not suggest for RGB power supply as you can’t see it lol, but other than that cable routing is simple and plenty of room for fans and drives with dedicated spaces for everything. Love it.

[7x Full Height] I really like the aesthetics of this case. It is a Mid ATX size but is large enough to build in easily. Be aware that the side fan bracket has three locations where it can be mounted, none of which will fit if you have most air cooled CPUs coolers or one of the larger modern GPUs (doesn't fit with my 4070 Ti or Thermalright Peerless Assassin). This is a minor gripe as the case has plenty of cooling front to back if you add some exhaust fans. Only two front fans are included, so you will likely want to add one to the rear exhaust and one or more in the top. Overall, I'm happy with the case as I knew these things going in and there are no other real options for those looking for a sleek looking case that blends in with your furniture.

[1x 2.5Gigabit] The Mini-ATX form factor is even smaller than the Micro-ATX. This motherboard is roughly 9.6 X 8.3 inches making it over an inch smaller than the Micro. That said, I installed a Ryzen 7 7800X3D on this board, which runs just fine. It doesn't have all the bells and whistle,s but if you need a small board that can handle current processors, this is a great board