Motorola Edge Glass Screen Protector

[Carabiner] For a first time camera owner, the Transparent Edge-to-Edge Glass LCD Optical Screen Protector for Panasonic Lumix DMC-LX10K Camera has been absolutely perfect. It was very easy to apply, and I have noticed zero air bubbles pop up since I first put it on. Easy to clean.

[0.03 lb] It is an amazing glass screen protector. The clarity is fantastic,.

[0.12 lb] This Glass Screen Protector was exactly what I was looking for. Purchased a different brand and the protector for the control display was the wrong size. This one fit perfect. Application was easy. It should work for a long time.

[5000 mAh] The screen protector gives me edge to edge coverage! This juice pak works well, it gives at least one full charge.

[Static Adhesion] this glass screen protector is a must for every photographer.. better safe then sorry. Very easy to attach

[0.1 lb] I was very happy I chose the Expert Shield over the other screen protectors. This one for my Pentax K1 is the second one I've purchased, the first being for my Pentax K3 III Monochrome. In both instances, the protectors fit perfectly. The total surprise is that they send you a set of TWO protectors, so I was able to apply the second protector on my wife's K1. The instructions were very clear and it was quite easy to install the screen protector in less than five minutes. Compared to the other screen protectors I've used, this one was very high quality; the edge almost seems to have a rounded off edge to it which makes it very sleek, and that gives me added confidence that it won't snag or catch on something. Additionally, this seems to be a little thicker than most screen protectors, so I think it will offer more protection. I'm very pleased with this purchase.

[0.1 lb] No issues. Installation was easy as you can use the lip on the inside edge of the screen for a guide while applying the screen protector. The touch screen still works flawlessly.

[Dry Adhesion] I was a bit worried when reading the mixed reviews for this product but ordered one anyway since it was fairly cheap. This screen fits over the a7rii screen perfectly, edge to edge. These protectors do take a bit of care to install correctly, mainly cleaning the screen thoroughly. Also I strongly recommend cleaning the area around you where you put this on as dust will be annoying if it is trapped. I wiped my screen well and then used a blower like the Giottos Rocket Blaster to blow away any dust that may linger on the camera as well as blowing around the area on the table that I was using to set the camera on as I installed it. Once you remove the backing and line up the edges to lay down the protector, set you camera so you can have one hand holding the temporary sticker tab (this is used so you do not touch the the protector with you finger) and with the other use your fingers to gently press back and forth as you slowly lay the protector down. If you get an air bubble, gently and slowly lift the protector to release the bubble and continue applying again. I had three air bubbles but a gently lift and then working them out with my other hand and I got a perfect seal with no dust or bubbles. Once again fitted my a7rii perfectly, the packaging has a sticker that designates that this is specifically for the a7rii

[6.5 x 4 x 1"] I purchased this screen protector for my Fuji X100s camera. It fits well. I did experience a little bubbling on the edge but that was probably due to the fact that my alignment was off just a hair when installing it.

[Glass] No matter what camera I purchase, if it has a viewing screen, I purchase a hard glass protector.