Passive Line Array Speakers

[Passive ] Easy-to-use, versatile way to send audio through the phone using the handset instead of the line. Small to pack, no power required.

[5 to 1000 ms/dB] Easiest hookup, and getting on-line with recessed speakers

[0.145 lb] I use this in my Rode blimp with Line Audio CM3 microphones in a wide ORTF array. It fits very snug and cuts down on cable clutter. highly recommended for anyone looking for low profile cables for stereo blimp rigs.

[7.7 lb / 3.5 kg] I saw this on your website for the first time, and had never seen anything like this before. I have seen much larger line array systems, but nothing as small as these array cubes. I was so drawn to it, that I decide to take a chance and purchase one for my band. We got it and found that it was so easy to set-up and it didn't take long to get the sound that we were looking for. It fills a big room nicely, but for smaller gigs I can just take the main unit and still have a great sound. I am glad I made this purchase.

[13.97 lb] The speakers arrived quickly and in excellent condition. The speakers themselves are excellent and I'm thrilled about the purchase. They are passive speakers, so setup was very simple -- I just had to run some speaker wire to both speakers from my amp. Best pair of speakers I've ever owned. Thank you B&H for your excellent tracking experience. It was fun tracking the package's journey.

[0.57 lb] I own a pair of both the Mackie SRM 450 passive and active speakers (same size). I already owned these covers for my passive speakers, but not the active ones. My passive speakers still look brand new after hundreds of gigs thanks to these covers. I started playing some outdoor gigs and wanted the same great protection for my active speakers. Also, these covers make the speakers easy to carry. Just make sure your set the speaker into the cover in the correct direction (bottom speaker facing right side) for the best fit.

[9.75 lb] I replaced my passive Logitech computer speakers with a pair of the Audioengine A2+ speakers and a small 6.5 powered subwoofer. This is a great combination for listening to streaming videos and music in my small office. I use the USB input for the signal from my computer and the RCA outputs to send a signal to the powered subwoofer (Acoustic Audio PSW-6 purchased separately). Shown in the pictures on the Audioengine DS1 stands. The only con is the volume knob is on the back. I would purchase them again.

[2.0] I have 2 of them in a passive bi amp setup with Fluance's reference speakers and it sounds fantastic. These amps have everything I wanted. Real buttons to contol volume and tone, lots of inputs, analog and direct mode, bluetooth, DAC, and nice look. The remote is too big and lack bass and treble controls but other than that it is a great integrated amp and very capable of delevering good sound. Having 2 of them in bi amp is amazing, lots of power reserve. I recommend this amp 100%

[Active 2-Way] .I switched over to QSC powered speakers from traditional passive speakers that needed an amplifier or powered mixer Sure, using powered speakers is more convenient but that is only the beginning. The QSC's SOUND GREAT! Warm, clear and wonderful. The K8.2 is small and easy to transport, but the way they sound is the main reason I love them.

[2x RJ45] I have been using 4 separate devices (6 RU) between my console and amps and passive speakers. A 31 band graphic, comp/lim, PEQ and active 3 way crossover. I purchased a DriveRack PA2 and loaded the latest firmware version, 1.2.0.0. This 1 RU processor has all of my existing functionality plus the ability to compensate for crossover delays and physical alignment of the drivers. My PA never sounded this good before. Proper phase alignment of drivers at the crossover points makes a difference that you hear.